Routing

c2811-1#sho file information nvram:?nvram:IOS-Self-Sig#3201.cer nvram:IOS-Self-Sig#3202.cer nvram:IOS-Self-Sig#3203.cer nvram:ifIndex-tablenvram:private-config nvram:startup-config nvram:underlying-config

Is there a way to setup variable QoS for a traffic flow? I have an 85 Mbps metro-ethernet WAN connection between two sites. One side has a Cisco 3745 router, the other has a Cisco 2821 router. We just recently installed two SANs (one at each site)...

Hi ,I have two sites with 1024k links in UK. The links behaves as if they are rate limitted even though i dont have any rate limitting set on the router. The customer for instance sent a 3meg file from a site locally to the UK site. it went up to ...

Hi All,I'm new to hardware load balancing.The present application we have in production is using apache/mod_jk as loadbalancer... which has capability to manage sticky sessions.I was going thru Cisco hardware loadbalancer configuration but, I'm unabl...

I have ASA 5510. I am letting my outside customers on FTP on my server (port range 49152 65535)Is it possible to limit the number of connections from one particular source address (My customer).Thanks,Manny

I am looking to reduce the monthly cost of dedicated private T1 to remote sites. At each site we have 5 staff users and up to 75 others that we provide internet access to at the building. At each site we have T1 for internet and 1 private T1 for da...

I have a router with lots of virtual interfaces. When one of the interfaces goes down every ospf route in the route table has its lifetime reset to zero.I thought only the changed routes should change not all of them, am I right?What would cause the ...

Can static GRE/IPSec tunnels be configured on the same router that is configured for DMVPN?

Our head office has two GRE+IPSEC Tunnels to our data center. This is a Primary and Backup setup using EIGRP internal. The Head office connects to the spokes over MPLS using BGP. So we have 2way redistribution with filters in place. The spokes us...

The cisco 2611 router is experiencing high cpu utilization during snmp polling . The snmp configuration is given below , the router is running a GD release .snmp-server engineID local 00000009020000024B0E6600snmp-server community <removed> RO 30snmp-...

Hi,WE want to Know that Is there 7613 Router support Voice Interface statnderd or not ? is there any extra card require for that ??Voice Interface Statnderd :-DSP Features CodecG.711 , G.729.. etc.CCS signaling -Q.SIG, R2 Signaling.etc........

How to configure cross vrf?How to verify cross vrf is working or not?

Can ATM be configured without ATM switches between 2 devices having ATM interface?