Routing

How come my static route is getting redistributed properly, yet the route map and access-list dont show any hits?switch2#sh run | be router eigrprouter eigrp 10 redistribute static route-map STATIC network 1.1.1.1 0.0.0.0!switch2#sh route-maproute-ma...

I have a Cisco 1841 router. Can I use standard (ex. Purchased at Best Buy or Walmart) compact flash memory when upgrading. I know in the past this would not work, especially with the Catalyst 6500 series.

Plataform: CISCO7609Version 12.2(18)SXF14, RELEASE SOFTWARE (fc1)I want to configure Load balance per packet over ATM sub-interfaces.To according cisco documentacion, the command ip load-sharing per packets is supported in 12.2SX versions, please I n...

This has bugged me for a while. A vendor manages our Internet gateway, it has an outside public mapped to an inside private for port 80 etc access. When I use http://(inside private IP) the main page appears, but when I use http://(public address), I...

All,I'm injecting ospf routes into eigrp. The route on the other side shows:D EX 6.6.6.6 [170/1662976] via 192.168.1.1, 00:00:35, FastEthernet0/0I want to change the AD from 170 to something else. On the other router, I'm running eigrp and it's re...

I have a cisco 2811 IOS C2800NM-ADVSECURITYK9-M),12.4(24)T with 4 WIC-1ADSL connected to 4 ADSL lines; two of them works correctly the other two lines no, they remains on initializing state. Is this configuration possible or not ?Thanks to all

Hello folks - I've a Cisco 3750 stack that needs to be load balance traffic over two Cisco 2821 routers. The routers are connected on a VLAN on the 3750. These routers are going to be primarily used for communication between two Exchange Servers (one...

Hi.Is it possible to create port channel (L3 interface bundling) between two L3 switches which ARE NOT directly connected? Both switches are connected with four interfaces to the L2 device, and those L2 devices are connected to two routers which are ...

I was trying to understand how the configuration below is possible, since the command "priority" always ask for a value next to it - either a percentage or a kilobps. In this case the "priority" command has nothing next to it and just below it we do ...

Hi,What is the difference between these ISDN BRI cards(functionality):WIC-1B-S/T and VIC-2BRI-NT/TE.In place of WIC-1B-S/T can i use VIC-2BRI-NT/TE interface module???Regards,

Hi,We are having 1760 Router along with VWIC-1MFT-E1 interface card. We are terminating E1 link which will be used for data traffic. Do we need DSP resources(PVDM) for this??Regards,

How can I limit the Bandwidth Utilization with "CUSTOM-QUEUING". I am only seeing policy on byte based.