Routing

I'm trying to follow the famous example here:http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a00808d2b72.shtmlThe only difference with my configuration is both of my ISP connections have static IPs (so it should be ...

Have a 7206 with a PA-E3 card. 2 Ports. Have many sub interfaces (se2/1.xx) which configured for Frame. Need to change the MTU on the main port, se2/1. Does anyone know what the default MTU is on this card, 1500 or 4470?

I am getting the below in my router which having EIGRP routingLUD-PAMC-R01#sh logSyslog logging: enabled (0 messages dropped, 6 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled) Console logging: level d...

HI , I am planning to link up 2 3845 routers with 1 3845 router at my data center. Will the data throughput affected?IS there any site have similar setup for reference?

We have having frequent disconnection issues with Cisco 2924 Management IP...If any one have information if this is a BUG!! Cisco Internetwork Operating System SoftwareIOS (tm) C2900XL Software (C2900XL-C3H2S-M), Version 12.0(5.2)XU, MAINTENANCE INTE...

Hiwe have two serial link connectivty for the Site A and Site BR1 ---------- Site A PRI ---------- Site B SECR2 ----------Site A SEC ---------- Site B PRIFrom my two routers we have two connectivity to Site A and B so From Site A they requested ...

i bought one 2811 router, HWIC 16A card, 2set octal cable and 16 modems (56K analog modem. i'll be using these set for modem pooling. do you have a documentation/configuration guide for these implementation. need help. thank you.

I have a problem....we have link to distribution switch...which was working fine...but now it is flapping continously...and ospf is flooding the network.My question is how to stop the ospf flooding?

This may be a simple fix and any suggestions would be appreciated. We have a hospital network, using Cisco 1200 series AP. We have plenty of AP coverage, signal strength stays excellent. The issue is we are beginning to run our main database system w...

Hi,If we define a dhcp pool range( one subnet for example ), exclude some IP from the same. And there is no ethernet interface from this router from the defined pool range. will this pool work?I think it wont! It may need one of the excluded IP to be...