Routing

Hi,We have two Internet connectivity in our office. One is through Leased line and other through Business ADSL line. Right now we are routing the Internet traffic manually through policy based routing in L3 Core Switch and NaTing through both the PIX...

We connect our Cisco 1812 with PPPoE to our ISP. We have a /29 subnet of public IP addresses. The ISP basically forwards all 6 addresses of the subnet through the PPPoE connection. The dialer interface is currently configured with one of these public...

I have the following problem:I have connected my central router with remote router over satellite link.I have incompressible situation. I lost comunication in remote router with ip phone and with server 1.1.1.21 port tcp 7778.But in that moment, i ...

i want to have an clear answer about which one is more powerful to be position as the Internet gateway to handle full internet routing and peer with alot of internet service providerto acheive the best performance/powerful and the lowest utilization...

I cant seem to view a Syslog with a Device Mgr. I have one router connected to a PC with Device Mgr software installed. I think I set all the enables for Syslog. I set the IP address for the syslog to report to the PC that Device Mgr is installed...

HiI am facing a peculiar issue in my network where we are having multilinks in many locations. When any one of the E1 in the multilink flaps, the reachability to the remote end of the multilink is lost for say 5 packets and comes back. Due to this OS...

In the 12.4 mainline documentation, the configuration example includes the command in the serial interface:frame-relay fragmentation voice-adaptive deactivation 50and this command in the policy map attached to the frame-relay map-class: shape fr-voi...

please whats the different btw the two NAT statements .ip nat source static 10.0.0.1 192.168.100.1and ip nat inside source static 10.0.0.1 192.168.100.1

My R3 acts as a frame-relay switch connecting R1. The frame-relay circuit is up. However, R1 is unable to see R6 thru ospf routing. Attached here is the config & diagram to explain. Hope some1 can help this novice. Many thanks.

we have two Internet Gateway 7606 with Sub720-3BXL , that peering with many service providers( more than 7, total uplinks 3G)running full internet routing table, we are facing high cpu utilization more than 35 %. we want to solve this issue since we ...

Is there any way to let this size of packet go through on an interface.when I ping and make the packet 8000 it fails.Any advice would be great