Routing

Hello,I currently have a iBGP full mesh of 6 routers in my internal network. My 2 edge routers have 1 upstream ISP connection each.My question is, if I learn a prefix, for example 7.0.0.0/9 from each of my eBGP peers, the edge routers that have thos...

We currently have a 3825 that was used for a T3 connection to the Internet, and the 3825 did a fine job. We have since upgraded the Internet link to a tiered gigabit link, on which we have currently contract for 100Mb. During peak busy periods, we ...

I have been unable to schedule recurring reloads on my WAN routers. Any suggestions are very much appreciated: kron occurrence RELOAD at 00:01 Fri recurring policy-list RELOAD kron policy-list RELOAD cli reload after running, the router drops cli ...

Has anyone seen this error and can point me in the right direction to troubleshoot.The following syslog message has been generated by xusred044c2903 with IP Address X.Y.Z.Z-08:00 %SYS-4-P2_WARN: 1/Traffic from permanent host 00:0d:56:92:5c:96 but see...

I have two routers connected by a serial cable. I have configured ospf but it's not working.this is how I did it/;conf trouter ospfnetwork 192.1.1.0 0.0.0.255 area 0and on the other router exactly the same but different network number but the same ar...

Can someone provide me an MQC sample config to start shaping traffic once a curcuit hits 75% utilization? I don't want to limit any specific host(s) or protocol. It will be used on varying wan speeds (T1, T3, Multilinks). Again the key word is shape ...

All...I am currently in the process of implementing EIGRP to provide dynamic routing across our entire network infrastructure which includes two paths to the Internet and two paths for our Remote Offices to the Corporate office via a MPLS cloud.On my...

HI. everyone.We have got a Cisco 7609 Router included flexwan module with PA-8T port adapter.Our plan is make a LLQ policy every serial line(about E1, T1)..But, I would like know queue-limit every device.for example.C7304 defalut queue-limit is 64 no...

I have 2 links between 2 routers.They have different OSPF costs.The links are GE and each go via several switches so a failure at one end does not cause link to go down at the other end of the link.If the Rx on one router fails this interface will im...

I have this problem:3 switches - 1 - 4503 and 2 - 3750They run in a cluster.There is one 802.1Q trunk from each 3750 to the 4503.On the 4503 i create 2 VLANs with SVIs.VLAN 2 - 20.0.0.1/24VLAN 3 - 30.0.0.1/24and the default oneVLAN 1 - 192.168.1.xAll...

Hi,I'd like to know about OIR in the 6500 and 7600 series, if the configuration remain at NVRAM or I need to set anything to erase the configuration when I remove a module or a SPA.

Based off of the following configuration, do you think this will limit all NON-VOIP traffic to 768? If voice traffic isn't going across, will it allow all other traffic to use the full bandwidth of the link?policy-map VOIP class VOIP priority 768...