Routing

Topology: There are three sites (3 routers) within radius of 30 kilometers. Site A connects to Site C via Site B. Site A has 2600 Rtr, Site B has 2821 Rtr and Site C has 2821 as well.For connections initiated from Site A for destination in Site C, na...

I have 2 subnets (192.168.1.0/24 and 192.168.2.0/24) on RouterA. How can I tell my routerA to take all traffic from my local 192.168.1.0 and route it to my S0/0 inteface which connects to routerB? Thanks in advance.

hi,we have a wic-1adsl module but our service provider is upgrading us to adsl2 next week. does anyone know if the wic-1adsl module will work with an adsl2 curcuit, not worried about the adsl2 speeds its just that the lead time on the adsl2 module is...

I have 8 E1 links.I want to equal per packet load sharing of that 8 links using static route.is it possible to loadsharing to that 8 links,if possibe what will be the command?pls help

HI,i have a 3845 with a external interface for peering BGP with the carrier for network 216.24.238.0 which works right. This network is on a loopback because I'm doing NAT.I also have a physical interface with IP 216.24.227.0 as primary and 216.24.22...

Hi, I am using WS-C6509-E Switch having Supervisor Engine 720 10GE (VS-S720-10G)with IOS sup-bootdisk:s72033-advipservicesk9_wan-mz.122-33.SXH3.bin Please let me know - 1- what is the limit of SPAN (Ingress/Egress) session using same scenario? 2- How...

I use a 7609 router to connect to 3 ISPs. Traffic monitored by PRTG v6 on 7609 sometimes go down and then up rapidly (pls see attach file) but traffic on interfaces of 3750 connected to 7609 don't suffer this phenomenon. All modules on 7609 are fabri...

I just installed one 1841 router and configured .but it shows interface up and protocol down, what will be the possible causes for.I configured with seriel interface

Have a customer that has two isps at different locations. They run ebgp to carriers and ibgp to an inside switch. The problem is this using the same internal AS number they have connected switch site A to switch site B and these learn each others rou...

I am looking for a router that can provide 4xT1 bonded MLPPP. I looked at the 1841 but can't determine if it will provided 4xT1 MLPPP. Please advise.

Does anyone happen to know where I could locate a stencil for the following module:WS-X4418-GBI've downloaded all the stencils available on the site, but none of them contained this piece of equipment.Thanx.

Hello,I have a pretty basic setup with an cisco 877 for routing our lan over adsl. Now we want to have an public wlan available in our shop. I think I need to set-up an 2nd vlan, and use that with Eth3 to hook up the accesspoint. Can anyone explain m...