Routing

Trying to connect c851 router to Internet via AT&T DSL via PPPoE.If PC connects to internet directly through DSL Modem [i.e. without router], no problem with email or any Windows client.If PC connects through router, router assigns an IP address to P...

Could somebody list down the Cisco modem/router for SMB that supports ADSL and ADSL2+.How to configure these ADSL boxes?

guys i have two question and if someone can please explain me......till now i thought that we only use next hop self command in ibgp......today i was doing something and i have seen this command for EBGP??? is it possible....as it was v strange???? c...

guys what the difference between the following two statemnets while redistirbuting connected subnets in ospfredistribute connected subnets metric 100redistribute connected metric 100 subnetsis there any diff or it s asame thing....cheers guys

Hi...!i have large intra network of switches in my organization. one of my parent switch reports error ....the error causes the layer 3 communication hanged for 2 or 3 minute but layer 2 communication wasn't stop and all my child switches were workin...

Hardware Recommendation. Although I am not new to network infrastructer I am new to the Cisco products. I am setting up a wireless network for a company and wanted to know what Cisco products to use. The system will be a VSAT internet setup which wil...

Can I retrieve netflow info on a 3550 with the EMI image. I have this for my WAN gateway. I also have a few 2950s and 2950EIs. Didn't know what the limitations were. Thanks.

Is it possible to set up vpn tunnels with our remote sites with nothing more than the Sup720-3b, and a FWSM? Someone told me that this couldnt be done without that VPN module or without buying a separate router but I find that hard to believe.

Hello..Trunk OF card BXM-622 OC-12 dont pass through of data.Detail: Stats trunk is ActiveBPCTIA01 VT Service BPX 8620 9.2.43 Nov. 6 2008 17:56 G-03TRK Type Current Line Alarm Status Other End 1.1 OC...

If you have full T-1 and an application that is sending accross TCP packets of 1514 bytes(with don't fragment set) will there be a benefit to using TCP payload compression on the link?Thanks

Hi Everybody? I've been trying to delete a subinterface I configured on a router but do not know how to do it. Can someone tell me how to delete a subinterface so that only the physical interface will remain. Thanks for your inputs. Tom

All,I have 3 public subnets. I have a situation that is going to require me to NAT 2 public subnets, and not NAT 1.Of these 2 that will need to be natted, I need to statically NAT a complete subnet to inside addresses.Int fa0/0ip address 1.1.1.1 255....