Routing

Hi,I dont know much about HSRP but i have one doubt can we use HSRP in L2 switch alone to achieve redundancyThanks,Hari

Hi,I wish to ask if the command "snmp-server enable traps memory" sends a snmp trap when it reaches a certain threshold of memory usage. If so what is the default value set for it to send a trap? Is it configurable in the sense that it will send tr...

Hi,I enable the auto qos on the WAN link. When I enable the SDM to monitor it. There is "default class data" only. I select the "nuber of packet tx". The result is the same. below is default "auto qos" config. I change the bandwidth setting only. Any...

perhttp://www.cisco.com/en/US/netsol/ns656/networking_solutions_design_guidances_list.html#anchor2High Availability Campus Network Design-Routed Access Layer using EIGRP or OSPFThe design guide recommends changing the spf, lsa, and hello/dead timers ...

I've got a 6506 that seemed to arbitrarily restart on it's own. Other than show logging, are there more detailed commands that will show more details as to why this happened??

We have various small branches with cisco 26xx/16xx series connecting to the head Office Cisco 2621 via IPVPN.Lately, the users are complainig of slow response. Please advise the ways to diagnose and monitor the traffic.

I know I should test it myself but just wanna see if someone has already noticed this before! If you do a copy/paste of router config from one oruter to the other does it also copy the MD5 key? I believe MD5 generates different hash value each time f...

Hi all,One of our clients has about 25 remote loactions connected to a central site using Frame relay and ISDN backup. The central site router is a 3845 and all branch routers are 1841s. As of now EIGRP is the routing protocol.The service provider he...

I have a 837 with the atm interface configured for dynamic IP (PPPoE) through a dialer. When I disconnect the cable broadband, interface dialer continued as "up" so that the packages are still routed through there, even though they have no way out. I...

Hi ALL:I will be convrting 6513 from Hybrid to Native Mode.I have used the EDC tool for conversion,but i have some confusion.1.Should i be adding the switch in transparent mode or server2.In the config the VTP mode is server and MST but i dont see an...

Can someone point me to a doc on how to configure DMVPN on a couple of routers with HSRP configured. Do I use the VIP address when I'm configuring the spoke tunnel interface?

Hi, I had IP multicast rate-limit configured on my E1 link in a 7206 router. The Card used was PA-MC-8TE1+.I have moved the link over to a Cisco 6506 device, and terminated the link on a SPA-8XCHT1/E1 module on the SIP 200 controller. The IOS version...

Hi, I have a point to point link between 2 Cisco 7200s that I'm being required to add VLAN tagging to. Here are the interface configs: Router A: interface FastEthernet5/0 no ip address duplex full ! interface FastEthernet5/0.253 encapsulation dot1...