Routing

Hi..I seem to be having a strange issue. I have routers A and B. B is connected to the network through A. I can ping router B through A but not from outside. When I do a tracert also the trace gets stuck at Router A's serial interface (the interface ...

Dear Team,my port forwarding in pix 506 E just failed. it has been working but not any more. I had done smtp forwarding as below:access-list outside_in permit tcp any host xxx.xxx.xxx.250 eq pop3access-list outside_in permit tcp any host xxx.xxx.xxx....

hi,I have a 2 locations which are connected by leased line with 2Mbps of speed.on both sides i have cisco 1841 with IP base images.The application used in this 2 Mbps line is Streaming video (IP DVR) and data file sharing .Now my problem is that when...

We have cisco catalyst 3560 which is normally connected to the corporate headquarter via ATM connection, as a backup we have also ADSL connection connected to the switch. If ATM connection dies, ADSL connection takes cares of the connectivity. This i...

Hi,I have many routers configured with EIGRP, and i want now to add message authentication to the EIGRP.As you know, when i enable the message auth on an interface, the router will lost eigrp to its neighbor and therfore the network will be down.Is t...

Probably a silly question, but here goes:We ordered five AIR-AP1242G-A-K9 Access Points under the impression that they had 4 antenna connectors; Obviously we were somewhat misinformed as it only has 2. We ordered antennas that have 2 antennas in each...

Hello All, THis is a long shot question but can anyone direct to a documentation that has information on what BGP community string SBC accepts? Thanks

We are running IGX 8430 Ver 9.1.16. Does anyone know what the break command (key) is or if there is one?

Hi All, Can anyone please come to my aid as to why three of my ten routers refuses my admission from the AS?.Even after clearing the lines. Here is the example output from one of the Routers.Access-Server#clea lin 6[confirm] [OK]Access-Server#r...

Hi All,We have a multicast running in our campus network. there is a requirement to extend the same multicast to mobile/home users over the internet. Is this possible and if yes what all will it take to enable this.-Sai.

hi,My config is as follow.class-map match-any ftp-trafficmatch protocol ftpclass-map match-any nbar-discoverymatch protocol fasttrackmatch protocol bittorrentmatch protocol edonkeymatch protocol gnutellamatch protocol winmxmatch protocol napster!!pol...