Routing

Hi MastersPlease advise my problem. I have branch office that will have PTP with 2xT1 and VPN through DIA. We want PTP to be the main path to our HQ and VPN as a backup. I attached diagram and please advise how to setup failover if PTP fail that the ...

I am trying to permit/deny access to certain ports from outside to inside ip addresses through PAT controlled 1841 router. Any help would be appreciated. The goal is to assign inside PC's with an ip address through login scripts then permit or deny w...

Thanks

Ok, so I'm migrating from an older Cisco 2501 router to a Cisco 1841 router and was hopeing you kind folks could glance at my config to make sure it's ok.Old Config off 2501:Building configuration...Current configuration:!version 11.1service slave-lo...

Hi,I have a cisco 3560 switch in a remote office where FE 0/1 is the WAN port and the port I need mirrored. We are using a really good bit of software called Observer Suite 12 that analyses all the WAN traffic, however our Observer consultant says t...

We have installed redundant PRP-2 modules in a 12010 chassis and we were under the impression that the Ethernet ports (eth0, eth1 and eth2) could be used for routing purposes.I have found documentation on the older PRP modules which states - " The PR...

Under sh traffic-shape fastEthernet 0/0, the output is Target rate = 640000 (bps), Sustains bits/int = 40000 (bits), Internal 62ms and increment 5000 (bytes). From my understand the total bandwidth allowed on the physical interface is 640Kbps. The ...

HiOn our network we use 6500/4500 and 2851 routers. On some of our connections we have large output drops "Total output drops: x" counter.Does anyone know how often this counter is incremented is it for every drop or say 1 in 100 i.e. is it limited i...

I have mrtg which graphs cisco 10k router traffic input and output on interfaces. It graphs well except on 1 interface (POS). On this interface the input rate on sh int and on the graph don't much. There is around 120M on sh int and around 6 on graph...

Have a scenario where WAAS is being implemented. The challenge we face is this:1. WAAS is being implemented at headoffice and all sites. Each site, including headoffice, have dual routers with dual links into an MPLS environment, and two WAE applian...

Dear experts,i have cisco 1841 router in that Iam trying block some of the sites using NBRbut i am unable to trace out the problem.plz go through the config and plz tell me where i was wrong,sh runBuilding configuration...Current configuration : 1284...

When redistributing protocols into BGP and using the metric command at the end, what value is that metric value. On cisco documenation, it saids its the IGP metric value, but how is that affect BGP? In other words in the decision process for BGP, h...

HI, I took console for 1760Router after booting the router.it's asking system configuration dialog then i gaiven nobut it's not accepting that even yes alsowhat could be the probelm and what are the points i want to check