Routing

I am trying to use a VPN tunnel as a back up to my T1 connection. The main site has an ASA5505 and the remote site with the Cisco2811. I am having a problem brining up the VPN tunnel when the T1 goes down. I have been searching for a sample config...

I've got a Cisco Catalyst 3500 switch. I have an Access Point in port 13 which in on VLAN 20. That AP pulls its IP from our Gateway, and that part is working fine. The AP itself also has a VLAN setup on it because I want the users to pull from a d...

Dear All, How i ussualy use 6748 module in catalyst 6500. but i want to install it in 7600 router. how to make it layer 3 interface(routed port/real port). whats the different when this module implemented in 7600 router. is there any pro and cons usi...

I have an ASA5505 with 3 interfaces configured: inside, outside, and DMZ. I want the DMZ to be able to access the internet through the outside interface, but not have any access to the inside interface. I've got a device on the DMZ network that needs...

Hi,I will configure the hsrp for auto failover when one circuit down. Attached file is the hardware installation. Those are the requirements- the default circuit is provider B- default gateway of all users is 192.168.12.10- when circuit B down, it wi...

hi ,Can any one tell me how ATM and MPLS works interms of technolgy.Few basic diffrences are required and which one is preferred in stablity and cost.Thanks ,Akber Mirza.

I have the following requirement.1. Each site (no PVCs) will get shaped to 128k. This is based on ACLs. 2. Within each shape Voice is to be given priority.My config is as followsclass-map match-any L_QOS_CLASS match access-group name L_QOS_ACLclass-...

Folks, can you help me here:Imagine I have a MPLS network, currently with:3825 router(headquarter)--- 3xT1--MPLS2851 router(1 branch office)--3xT1--MPLSNow I want to evaluate how many future branch offices I can handle with this 3xT1 in my headquarte...

I have a VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1 on cisco router 2801. what interface to setup for this card?

chaps,Got my first star yesterday. It feels good. Francisco

Hi all, It is strange that I don't know why the 26 router will learn below network via ospf method, I think it should be learned via 17A ebgp Router (192.168.1.2). Anyone know what happen on it ? Thank you 2600#sh ip routeO E2 172.20.1.0 [110/1] v...

Dear sir,I have configured bgp in my router. Here is my configuration.=======================router bgp 38031 bgp log-neighbor-changes network 203.112.72.0 network 203.112.73.0 network 203.112.74.0 network 203.112.75.0 network 203.112.76.0 network 20...

which technology is better for redundancy in switch HSRB or GLBP?

Hi everyone do i need to set timeout time on an inspection command and how long it should be set at?ip inspect name SDM cuseemeip inspect name SDM dnsip inspect name SDM ftpip inspect name SDM h323ip inspect name SDM icmpip inspect name SDM imapip in...