Routing

I have a 7604 with SIP-400 and a SPA-1x2GE. This is connected to our provider's Metro Optical Ethernet (QMOE) at layer 2 - we apply L3 routing on our interfaces. This is at our data center (DC) and is connected at full gig speed. Our other sites a...

Please i have diff staffs, and i want top give them diff level of telnet permission.please how will i achieve this witrh line vty ......also please explain all the vty lines. e.g line vty 5 15

Hi. Our ISP (Pipex) has given us a single public IP address with a subnet mask of 255.255.255.255, and we're trying to set it on dialer 0. Dialer0 is complaining about the subnet mask, is there any way around that?Thanks

Hi. I have 2821 with zone-based firewall. I have 2 zone: in-zone (internet) and out-zone (LAN). For in-zone i have next rule:!!!!!!!class-map type inspect match-any PentarIncomingService match protocol pop3 match protocol dns match protocol smtp matc...

Hi all,I'm curious if anyone else is using a switch for WAN connections.I am looking at upgrading our IPS uplink from 9Mb to 20Mb. We use 6 T1's currently in a 2811 router, but our new link will be an 100Mb Ethernet (copper) connection rate limited t...

Hi,I want to reserve IP address assignment Based on MAC in DHCP configuration in Cisco Router. I am unable to do it, please help.

Hi,I am trying to redistribute RIP into OSPF but im getting the following message;"Only classful network is allowed"And because of this i am not getting any RIP updates in my OSPF domain.

I have the following config class-map match-any L_QOS match access-group name L_BTSclass-map match-any E_QOS match access-group name E_BTSclass-map match-any voip-sat match ip dscp efpolicy-map sat-qos-child class voip-sat priority percent 33 ...

Hi all, I am testing the failover fo the setup network but it seems fail.Basically, the connection is work in normal condition. But when I try to makeRouter 26 (10.1.1.2 port down ) and Router 36 ( 172.20.1.1 port down ). I expecttraffic from Router ...

Hi all,Can BGP run load balance? As I know,BGP will choose the BEST route and installed in the routing table. I just think only Load sharing can be done rather than load balance. Am I right ?

Hi,We are using two ISP A and B, I want to send the HTTP traffic via ISP A and mail SMTP traffic via ISP B. Would you please let me know the simple configuration for this concept.As per the attached fig.

our company has 4mbps adsl connection using a cisco 1721 router, we want to add another 3mbps adsl connection. we want to integrate the new connection by buying another wic or buying another cisco router for load balancing ? what would be a better op...