Routing

Hi all,I'm curious if anyone else is using a switch for WAN connections.I am looking at upgrading our IPS uplink from 9Mb to 20Mb. We use 6 T1's currently in a 2811 router, but our new link will be an 100Mb Ethernet (copper) connection rate limited t...

Hi,I want to reserve IP address assignment Based on MAC in DHCP configuration in Cisco Router. I am unable to do it, please help.

Hi,I am trying to redistribute RIP into OSPF but im getting the following message;"Only classful network is allowed"And because of this i am not getting any RIP updates in my OSPF domain.

I have the following config class-map match-any L_QOS match access-group name L_BTSclass-map match-any E_QOS match access-group name E_BTSclass-map match-any voip-sat match ip dscp efpolicy-map sat-qos-child class voip-sat priority percent 33 ...

Hi all, I am testing the failover fo the setup network but it seems fail.Basically, the connection is work in normal condition. But when I try to makeRouter 26 (10.1.1.2 port down ) and Router 36 ( 172.20.1.1 port down ). I expecttraffic from Router ...

Hi all,Can BGP run load balance? As I know,BGP will choose the BEST route and installed in the routing table. I just think only Load sharing can be done rather than load balance. Am I right ?

Hi,We are using two ISP A and B, I want to send the HTTP traffic via ISP A and mail SMTP traffic via ISP B. Would you please let me know the simple configuration for this concept.As per the attached fig.

our company has 4mbps adsl connection using a cisco 1721 router, we want to add another 3mbps adsl connection. we want to integrate the new connection by buying another wic or buying another cisco router for load balancing ? what would be a better op...

Hi Sir,I am config a Cisco 3845 router ios version 12.3(11r)T2. This router current have a AIM-ATM-4E1 connect to WAN. When I plug in the card NM-1A-E3 into the router. The E1 connection will lose (ATM0/IMA0 will up and line protocol will up but the ...

Hi,We are using two ISP A and B, I want to send the HTTP traffic via ISP A and mail SMTP traffic via ISP B. Would you please let me know the simple configuration for this concept.As per the attached fig.

Due to EOS / EOL issues, we need to move off of a multiple 7401 strategy for our WAN edge. We need to support up to 6 DS3's from various carriers. Any recommendations for a redundant consolidated platform ( 1 or 2 big boxes)vs. multiple single boxe...

why we configure default-gateway on a switch ? Can someone give an example ? As i know switches makes forwarding decisions based on layer 2 ( i mean layer 2 switches).

I was wondering if anyone knew what the maximum amount of traffic that can be passed over GRE tunnels for this sup. I seem to think that it is 35Mb, but not really sure. Also can I add an ASIC daughter card to improve this?