Routing

I have a 2811 router running IOS version 12.4.13 and inserted a WIC-1DSU-T1. Running show diag gives the result that the card is "not supported/diabled in this slot".I have tried different slots all with the same results. What am I missing to enable ...

Hi,Can anyone help me understand the BGP scan timer. Any searching yeilds lots of results in relation to MPLS etc. Is there a document that outlines it general prupose?Regards

Hi everyone,I've been trying to deploy a L2/L3 switched based infrastructure that will provide the attached IP multicast fault-tolerant environment.I have sources on one site multicasting a Video stream over dual Eth/IP ports. Each of these ports is ...

Hi,I need some one help me with my problem.I work for a small organization as an network operator.Here in our company they have brought 2 WAN Leased link of2 Mbps each from the same ISP.The ISP according to their policy provides a block of 8 Public i...

Hi!I have cisco 837 Router with ADSL connection with fixed Public IP and one LAN IP 192.168.1.1. The LAN interface is connected to a LAN Switch where an application server 192.168.1.2 is also connected.Is it possible to forward the telnet traffic hi...

i have 2821 router with 2gb int one is used for isp and other for the firewall i am planning to add one more isp from different vendor which will be used only for a set of systems only those will be using the link other will go via exsisting isp how ...

Hi i am getting the following error on my 700 router details System image file is "disk2:c7200-jk9s-mz.124-19.bin"Jun 21 20:55:53: %ENTITY_ALARM-6-INFO: ASSERT CRITICAL PO3/0 Threshold Cross Alarm - B3Jun 21 20:56:03: %ENTITY_ALARM-6-INFO: CLEAR CRIT...

While reading the online Net Academy material I came across this quote:"A nonexistent class can also be used within the policy-map configuration mode if the match condition is specified after the name of the class. The running configuration will refl...

Dear allI want to use sup720 with maximum throughtput, but when I looked into SUP720 datasheet,it was "DFC required"my question is that how should I use DFC.I want to select sup720-3bxl to achive (400mpps)regards

I am having a cisco 2800 series router.I am having ISP link with RJ45 termination which i can connect on an ethernet interface. when i am trying to connect it on the FE port of the router with IP nat outside command on FE then it stops working. but o...

My customer connected a 2960G-48TC-L to a preconfigured C1841 router. The router was hard coded to 10 Full and the 2960G to auto/auto. The 2960G would only auto configure to 10 Half. Hard coding the 2960G to 10 Full knocked down the link as did se...

Can you use a cloned hardware address with the this cable modem? I have an active linksys cable modem but I would like to replace it with an HWIC card.

I have a call manager version 4.1,when i try to search for the cdr of a user/extension, i get a message that there are no matching records found. Help me please

I'm planning a backup wan connection that will use an ASA and vpn tunnel as a backup method of WAN connectivity. Right now we have a private BGP AS on a frame, and my idea is to have a floating static route on my WAN router pointing to my ASA that w...