Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

HI,I'm studing for BGP exam but I have some doubts on how the redistribution process works, so I would like to discuss about it. Netpro.txt contains the explanation of the issue, and confs.rar the configurations of the small lab I created.Thanks in a...

Marcofbbr by Level 1
  • 1183 Views
  • 5 replies
  • 0 Helpful votes

We have 6 new T1's coming in on a T1 card on a 7206. We are having a problem with PPP multilink on this card. Here is the configuration for the multilink and each of the T1s:interface Multilink1 ip address 10.105.255.174 255.255.255.252 ppp multili...

In an MPLS scenario for a large number of sites spread across globe, accessing the app. in datacenter, packets are able to reach the target gateway edge router but the network beyond that (the datacenter app)are not accessible. What could be the prev...

aksher by Level 1
  • 691 Views
  • 3 replies
  • 0 Helpful votes

HelloIm using a Cisco 1841 where FastEthernet0/0 is the customers LAN, and FastEhternet0/1 is the WAN uplink.When im trying to set the wan uplink to mtu size 1524 i get the following error: % Interface FastEthernet0/1 does not support user settable m...

Leifkaare by Level 1
  • 2235 Views
  • 4 replies
  • 0 Helpful votes

Hi all.I have a problem in regard with a international serial link.I connected the serial interfaces with DTE cables on both ends but when I enter the show int serial command on both ends I get that the interface is up but the line protocol is down.O...

HelloI have a problem with trobuleshooting ATM interface errors.On my atm interface i noticed high number of drops and flushes and some CRC errors can somebody help me to figre out what can be the reason of the errors.This is the output of sh interfa...

-cybermen by Level 1
  • 1463 Views
  • 6 replies
  • 0 Helpful votes

I've noticed that in newer IOSs(i'm on a 7204 with 12.4(13d)) that copying configs to and from the router via xmodem are no longer supported...is there a reason for this? Putting a config to a device via xmodem was super convienient...

zztopping by Level 4
  • 996 Views
  • 6 replies
  • 0 Helpful votes

Resolved! BGP Requirements

Hi,We're implementing BGP and we already have our AS number, and peering arrangements with 1 ISP (the other one is coming up next). In fact we already have an entry on our border router. Basically we are implementing BGP in order to provide us with...

Hi...We have configered the router in TACACS but we are not able to go on enable mode .Router ver - 11.3(2)please find below config aaa authentication login default group tacacs+ localaaa authentication login authtac group tacacs+ localaaa authentica...

Our current configurations for our lan are 2960 swithces that get their ip's from DHCP (not sure why our admin wanted it this way)so the basic configurations are this!interface Vlan1 no ip address no ip route-cache shutdown!interface Vlan134 ip addre...

Dear sir,We have 7206 router in that we want to add Isdn bri and pri lines over adsl so plz give me the part no which will suit on 7206 router.Thanks&Regardssrini

Unanswered Topics