Routing

Hi, all!Is there any Cisco product that can configure as teleco's ISDN switch? I cannot sleep well because of this question. Please help me!Thanks.

Hi i having trouble understanding the concept of a WAN connetion.how do ISP's run a leased t-1 line all the way from CAlI to NC or such...i just dont get that..i knows the cable isnt 3000 miles long.Does the ISP have mutilple locations in the U.S. an...

One of our locations is configured with a PRI circuit and the employees there are reporting to me that they experience intermittent problem with static on calls coming into and going out through the PRI.If they hang up and dial back then they will ty...

I'm a novice having difficulty with configuring my 871 router with the virgin network on a cable modem. If anyone can give me a set of guidelines for this I'd be grateful.

I confused myself here...my last hop before I hit my ISP is 198.168.96.2 the router that I'm on has a Gateway of last resort of 172.19.207.5 which is the ethernet interface on my core router. Now question is if someone needed a gateway to point to to...

Attached is my router config. Can someone please help me figure out why these redistributed routes are showing up in the eigrp top table. Here is the show ip eigrp top output:Router#sh ip eigrp topIP-EIGRP Topology Table for AS(100)/ID(192.168.254.6)...

Hi, I am going to setup a new point to point internet link that is fiber. It is a fractional T3 (4.5Mbps) Is there anything that I have to setup for on this interface? I know that when setting up a fractional T1 you have to specify service time slot...

this is the diagram of mi network,i run static route through the isp from the branch to the hq. what i want to do now is to make branch network a go through isp1 and branch network b go though isp 2 to the hq.pls tell me what o do.can i run pbr on s...

We are looking to configure out of band management for our remote cisco routers/switches and wanted to get some thoughts on the best practice for this. We are thinking of using a analog line connected to a modem and then console from there. Anyone ...

Hello my computer does not see my wireles netork

Hi, I would like to get some clarificaiton on the differnce between L2 and L3 EtherChannels! Thanks, SK

I know it's possible to bond T-1's, and most providers will bond up to 4 T-1's. Is it possible to bond 2 or more DS3s in the same fashion? Also, what type series router would I probably need to look at to handle this? 7200 series with a NPE-G1 or ...

I am compressing my frame relay packets to better utilize the bandwidth at one of my low bandwidth sites. I also need to shape my packets, especially since one end of the link is aggregating traffic from many sites. Does anyone know if the compress...

I have an Cisco 1812 Version 12.4(15)T3line vty 0 3 exec-timeout 0 0 transport input none transport output nonerouter(config)#no line vty 0 3% Can't delete last 5 VTY linesdoes anyone have an idea

Hi,I have five customer sites that each run a Cisco 1721. I'd like to be able to remote into each router securely. My initial thought was ssh but then I thought about VPN; when I purchased the boxes I bought them with that in mind.Anyone have a prefe...