Routing

I have 3 locations viz. A, B & C. A is central location and is having E1 to B & C. For backup there is also a link between B&C. I have configure Static Route configured so that alternate path can be used if any link direct from location 'A' is down. ...

hello to everyone I have a problem with a router 877, the problem is that I need to change the "mac address" a VLAN, but this will not let me do it. and if we can not change it, you can disable the function of the router VLAN? The problem is that I n...

Any experience with USING A FULL DS3 What router would you recommend?For use with an internet feedThanks,

Hello,I was wondering if anyone has used a cisco router in place of a devicelike this?http://www.polycom.com/usa/en/products/video/security_firewall_traversal/vbp_4350t_series.htmlI have a couple of polycom codec's and I have the need to do nat/firew...

HelloI would like to ask which application I can use from a notebook to a router if i use a rollover connection for console.Basically my situation is as follows:I have an IBM T43 Thinkpad. It has no DB-9 connection. It has an LPT, network, wifi, mode...

Hi all,Am facing a little confusion.Here the point :I have 2 2621XM with 2 WIC 2 A/S to connect using a LL and 2 modems. this connection is just a backup to an existing E1 link.Is it necessary to configure my serial interfaces on async mode ? First i...

Hi Expert,I am newbie in this area. 1. We want to use Netflow to monitor MPLS network, is there any specific document for 7600 platform ? 2.Is there any effect on CPU load, interface etc ? 3. Can Netflow monitor specific vlan, vrf or multilink instea...

hi all,unfortunately i do have a huge problem with a cisco 876 router:it is configured via SDM utility but the dialin with my provider does not work!!I have added 2 dns-servers manually as well as the connection details for my dsl -provider. The rout...

Hi,I just not sure of the next step here. I have go a remote office on a Cisco 877 connected to a Cisco ASA over a DSL line. The remote office can connect to all servers etc over the VPN accept for the Internet.The internet needs to go over the VPN...

i have configured nbar protocol on my cisco 3825 router interface that is connected with internet just to check which type of traffic is going towards internet from my users. I shows me different types of traffic which i never allowed in my firewall ...

Hi.i have little problem.i have two 7606 wan edge routers.this two routers connect to wan routers over wan network.i have to configure tunnel interface for wan routers and 7606 routers becouse my wan conectivity in this way is provided with Vsat netw...

Dear Experts,Currently we are using EIGRP routing protocol in my network.Planning to move to OSPF.Pls suggest me whether I can go for it and also tell me the basics on IS-IS.

Greetings,I have a customer that has 2 sites. 1 connection via broadband wireless (latency, drops packets...etc) and another via an MPLS connection. For the scope of this question I won't get into the technicalities of why we have routing the way w...