Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi thereMy understanding of half-bridging according to http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/6500series/76cfgatm.html#wp1307151 says, that an Ethernet segment with several hosts, bridged into an ATM PVC...

PerseusDK by Level 1
  • 474 Views
  • 2 replies
  • 0 Helpful votes

We have 2 different circuits running between same cities. Circuit 1 is dedicated to use Stream Box video streming traffic. We have applied access list at our Router to route traffic appropriately.Main issue we observe is that, Packets are not matchin...

HI,I have a problem with the IP Communicator registration with the appropriate call manager. Basically we have two call managers in out network at the movement, one with the version 4.1 and the other with 4.0 version. We are slowly migrating all the ...

abeid by Level 1
  • 583 Views
  • 1 replies
  • 0 Helpful votes

VPN

HI,I am a beginer in VPN concept i want to study the VPN concept and also its configurations. Can anyone help me by sending any link which is helpfull for me to start my studies..Regards,Sham.

I have a problem on a 3825 router with 3 VWIC 2mf E1 i/f's, and an ATM aim module.My telco has supplied me with 3 by E1's configured as a 6Meg bundle. At the far end this then breaks out into a frame-relay network on which we intend to connect to mut...

Resolved! BGP next hop ??

Scenario :-R1--IBGP--R2--EBGP--R3R2 applies community AS:NN to inbound updates of R3 route-map test permit 10 set weight 0 set origin igp set community AS:NNthen while sending the updates to R1 and applies the following route maproute-map set-next-ho...

Hi,I'm using this topology in my lab for clustering.as2r4 ---- as2r1=======================as2r4#sh run | s router bgprouter bgp 65002 no synchronization bgp cluster-id 65222 bgp log-neighbor-changes bgp confederation identifier 2 bgp confederation p...

Is there a way to use a 3600 router as an ATM switch? I want to set up a learning lab and have lots of spare ATM IMA cards for 3600 routers, but would also use the lab to test routers before being deployed to production.Thanks in advance.