Routing

hiwhere do i need to use this Comand:int y/yip rip v2-broadcasand in MSTif i need to make SW1 Root for Instance 3the Command shoud be:spanning-tree mst 3 root primary or priority 0??10xs

Next week our company will be turning up a full rate DS3 and I am trying to figure out what is the best method to manage (limit) how much bandwidth a protocol can potentially use. Right out of the gate I want to only allow 15Mbps (in and out) of the...

Hello everyone,Thank you for looking at this post. I have a bit of an issue that I cannot figure out.I am attempting to setup a NAT configuration for an Internet provider but something is going on. I have changed the IP's below so they are not thos...

I'm trying to use "ip local policy" to route locally generated OSPF messages through a different interface. It appears that I'm able to accomplish this for all OSPF packets except Hello (multicast to 224.0.0.5) messages. Is there a way to use local...

Hi,We have 2 E1 links from 2 different providers. We have connected them to 2 different ports of VWIC2-2MFT-T1/E1. NowI want to make them as a one single pipe for my voice traffic. I am using 3825.

Hi, I have a VWIC2-1MFT-T1/E1 card on 2801 router with orange led of local alarm active.What this means? What is the cause of this alarm?I try to find some docs about E1/T1 alarm but I don't find anything.Thanks Enrico.

Hello...I need to encrypt a dedicated serial link between two Cisco routers (1760 & 2811) both capable of doing VPN, tunneling, etc. I'm not sure where to start because I'd like to configure fast encryption method that doesn't eat the BW and keep th...

Is there a way to do a factory reset on a Cisco 877 router, which has password recovery functionality is disabled? Tried ctrl+break at various points in boot up as per cisco documentation, but no luck. Wonder if anyone else has had this problem?

I have a 2620 and a 2610 router. Hardware is not the issue because when I did a hardware reset indivuidually the interfaces came up fine. However, once I used a crossover cable, I can't get them to be up together. I am so mad because the process is...

Currently I run 2 routers(7206) and a core switch(6509 acting as a vlan router/switch), BGP to two different providers and EIGRP internally. The 2 routers run HSRP and the switch points to a HSRP as the gateway.Currently R1 is the primary router all ...

Please check the attached topology. Well I have two vlan in the switch. And the switch is connected to route '1''s fa 0/0 using 'dot1q' encapsulation. And the two pc there can ping each other. Router 1 is a border router linking to a wan router(Honol...

Hi, I use a compact flash reader to copy ios image and cme files from PC to the flash card, and insert it to the router. While booting, it reports % Crashinfo may not be recovered at flash:crashinfo% This file system device reports an errorOn CLI,Rou...

Thanks in advanceCan some one help me argentallyOne of customer wants the solution on how to connect Ho with 14 branch offices via L2 connectivity provide by different isp.In short scenario is just like belowHO--------ISP---------Branch office1HO----...