Routing

Running 12.4I have some sla monitors configured one tracks the fe interface the other a dialer.The dialer config gets removed after a reloadThis is the config before reloadip sla monitor 1 type echo protocol ipIcmpEcho 212.159.13.49 source-interface ...

Is there a supported antivirus product for LMS 3.0? I had Mcafee running, and it was giving me all kinds of problems, so I had to stop it. What can I use?

Just want to know if the CIR that providers give to customers have burst just like FR? example, they give me 128k for my link. Do it has a burst like 256k if your using MPLS VPN. Please enlighten me. Tnx a lot!

I have a 3845 that we just found, it doesnt have a flash card installed so when it bootsup it goes to rommonrommon 7 > resetSystem Bootstrap, Version 12.3(11r)T2, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) ...

Hi,we are trying to cascade cisco 2948G-GE-TX with cisco 3500XL series but the link was not getting up pleae let me know what are may be the root cause for the above issuesregards,Vinoth

Hello,We bought Aironet 1410 Wireless Bridge ( AIR-BR1410A-A-K9 ) but this product does not suitable to our project, actually we need Aironet 1410 Wireless Bridge N Type ( AIR-BR1410A-A-K9-N ) Does Cisco has any interface converter to N Tpye?(We cann...

My organisation is implementing a secondary ISP link (4Mb) to coexist with our primary ISP link (10Mb).The powers above would like to make use of the 4Mb link rather than have it sit there purely for redundancy.We are undergoing the process of reques...

Hi all,When I installed new GLC-LH-SM to card WS-X6724-SFP on sw 6509, the switch disabled interface and gave an error message: "%PM_SCP-SP-3-TRANSCEIVER_BAD_EEPROM: Integrity check on transceiver in LAN port 1/20 failed: bad key".It also had the sam...

Hi

Hi allIn ospf process,they require inject a default route to area 4, should i configurate the area 4 is a stub or totally stub area?one more a question:if i wanna an area in ospf process can only receive the inter-area route and must not receive the...

I have two different ISP's connected to seperate routers, and multiple IP blocks with your typical BGP configuration for failover. My issue is that one of my /24 networks sends and recieves more traffic than some of my other networks, and one of my ...

hi , everybody please help me in cause,in my school has 2 adsl [dynamic IP from ISP] i connect 2 line into my router [R1841+2WIC-ADSL] my config in file. if 2 link is normal, everything is good butin case when link 1 down, service in route-map on lin...

Hi All,I have been stuck with NAT problem. It gives me a error my ASA. like thisNo translation group found for icmp src fugen-dmz:172.16.2.253 dst outside:4.2.2.2 (type 8, code 0)These hosts are coming from interface etherent0/3 (named as fg-idsys) o...