Routing

Hello, how many Frame-Relay circuits per serial interface could I implement on a 1600 series router?Thanks everyone...ASQ

Hi Can Anyone advise on what are all the things that we can troubleshoot in logging into GSR Line Cards.. We are suspecting issues only on Gigi LC of our GSR...Thanks in advance..

Hi,I've a problem with my DSL controller, I configured this one but the controller is flapping UP-DOWN-UP-DOWN, I tried several parameters but still NOK, have you an idea why? Thanks in advance.HERE's my config.controller DSL 0/0/0 mode atm line-term...

Hi All,How does etherip work?Lets say now that Host 1 sends a packet to Host 2 over the etherip tunnel (btw, they are on seperate LANs), how is the packet built and what does it look like?Lets say a normal IP packet like the below :-Frame 9 (614 on...

Hi, I have an office on a VPN DSL line of 1mb downstream and 288kmps upstream and the ms can be around 500. Before we upgrade the line can you see anything wrong with this output?sh dsl interface atm 0ATM0Alcatel 20190 chipset information ...

I'm trying to use the followin command on a 2801 (IOS 12.3.14) and on a 2811 (IOS 12.4.5)show ip nbar protocol-discovery stats bit-rate top 10Why does it show bit-rate information only at one of the interfaces?Ex.: Serial0/1/0 ...

Hi,I have a problem with asymmetric routing (traffic flow) that doesn't allow me to load-balance between 2 or more links, as most of TCP application disconnects. Kindly note the asymmetric path starts at the router right near the source (client). I h...

I have the age-old problem of trying to get HSRP working on a couple of routers that are connected to an MPLS network via two Ethernet LES circuits. As ever when the PE goes down, the interface on the CE stays up as the intermediate switch provides t...

I have a newbie question involving the following scenario:WAN Router with 2 WIC cards are connected to 2 ISPs:Internal network > Firewall > WAN Router (ISP1 1.1.1.1/24, ISP2 2.2.2.2/24)Publicly available servers are currently nat'ed by the firewall t...

Hi,I wonder if anyone can help.We have a connection to an external supplier, where we have a Cisco 803 ISDN router connected to the OUTSIDE interface of our firewall using a public IP address from our assigned range. One of the devices on our inter...

Hi there,I have kind of a routing problem. At the moment I have a cisco 1800 Router (10.17.2.1) which is the default Gateway in a 10.17.0.0/16 Net. All traffic to other 10.x.x.x Networks is routed over the Routers MPLS WAN Port. The default Route (fo...

I am a little lost on how to set up an ATM connection with limited bandwidth on a 6509, any help? Thanks

Can you configure multiple nat addresses over the same port, e.g.ip nat inside source static tcp 192.168.1.2 80 203.214.17.212 80 and ip nat inside source static tcp 192.168.1.3 80 203.214.17.212 80