Routing

I have the age-old problem of trying to get HSRP working on a couple of routers that are connected to an MPLS network via two Ethernet LES circuits. As ever when the PE goes down, the interface on the CE stays up as the intermediate switch provides t...

I have a newbie question involving the following scenario:WAN Router with 2 WIC cards are connected to 2 ISPs:Internal network > Firewall > WAN Router (ISP1 1.1.1.1/24, ISP2 2.2.2.2/24)Publicly available servers are currently nat'ed by the firewall t...

Hi,I wonder if anyone can help.We have a connection to an external supplier, where we have a Cisco 803 ISDN router connected to the OUTSIDE interface of our firewall using a public IP address from our assigned range. One of the devices on our inter...

Hi there,I have kind of a routing problem. At the moment I have a cisco 1800 Router (10.17.2.1) which is the default Gateway in a 10.17.0.0/16 Net. All traffic to other 10.x.x.x Networks is routed over the Routers MPLS WAN Port. The default Route (fo...

I am a little lost on how to set up an ATM connection with limited bandwidth on a 6509, any help? Thanks

Can you configure multiple nat addresses over the same port, e.g.ip nat inside source static tcp 192.168.1.2 80 203.214.17.212 80 and ip nat inside source static tcp 192.168.1.3 80 203.214.17.212 80

Headquarter and several branch office, Cisco3725 (HQ) anche Cisco-2811 (BO).WAN connections on Ethernet (transparent bridging over WireLess).BackUp connection are ISDN-Dialer (DDR Routing).Dynamic Routing via EIGRP.No problem in case of TOTAL failure...

I was wondering. We have two ds3's going to the same service provider. One DS3 for one 3845 and the other for the 2nd one. I believe they are being used for load balancing too.Should the configs be exaclty the same if these are configured for HSRP?an...

Hi Everyone I'm trying to set up an out of band connection to a new router. How do I go about doing that? Does anyone have a config they can share or point me to the right document to do this? Thank you in advance!!

Hi, I have a Cisco 877 DSL router connected in a remote office with nothing connect to the Vlan1 (4 port switch on back) to bring the VPN up, how can I add a loopback to test the VPN is working?I can ssh to the outside IP and back the change.

I have two 2620 routers and one 2651, i have trouble getting the latest ios versions for this series. Can anyone help?

Please let us know if this is true or false.When you have a route-map defining a clause with a deny statement on it and have an access-list that does not define anything, this route-map clause will not have any effect on the routeseg.!route-map cisco...

Can anyone tell me what could be the issue with SFP(GLC-LH-SM ) which is supported by this platform is not getting dedected.IOS :c3845-advipservicesk9-mz.124-10a.binthe same is working in Cisco Switches.

I cant find what software to use, on a 2811 router with HWIC-2CE1T1-PRI.The "Software Advisor" does not have this module listed.Any help?