Routing

can anybody tell me what ios i would need to run the isis routing protocol on my 1760 routerregards melvyn brown

HI,SDM will not start. It stalls out on the launch page. Just says loading Cisco SDM. Please wait...I'm upgrading numerous routers to the 256MB flash. Then I'm pre-installing the IOS, and SDM to the new flash using a spare router. On the very first...

CiCisco router on one side, Zebra running ospfd on freebsd 6.2 on the other, Ethernet interfaces. First 30 seconds all is good, then everything stops for a split second and it's good again, this repeats continuously. I see this on the Cisco side bu...

I'm trying to configure a fiber trunk between a Catalyst 3560 switch (Gi0/1) and Catalyst 3750 switch (Gi2/0/50). The SFP modules (GLC-SX-MM) are seated and the cables appear connected fine, but I get no green LED lights on either switch. Port setti...

Good day I'm trying to traffic shape a circuit I have currently it is set up to take the full T1 1536K what I wanted to do is shape that to only take 1M how or can someone point me to a doc that tells me how to do this? Thank you in advance!!!

necesito su ayuda en español por favor, mi duda es: cual es la diferiencia entre el CISCO 4503 y el 4503-E?tengo un CISCO 4003 ¿como puedo ver el historial de utilización del CPU?

which model of the 800 family router and IOS version let me setup subinterfaces in a ethernet port?:interface e0interface e0.10 encapsulatin dot1q 10 ip address ......interface e0.20 encapsulation dot1q 20 ip address....I try in an old 2514 and 2600...

We have recently switch MPLS providers and they are requiring that we use CoS tagging on our router interfaces. All of our sites use 1800 or 2800 series routers. When I create all of the maps and attempt to apply the CoS to the interface, ny routers ...

Hi all.I have a range of 5 public ip addresses from my isp. I have a 1750 Cisco router with 1 Ethernet and 1 FastEthernet port.The E0 connects me to my ISP. I have it configured with 1 primary and 1 secondary public ip address.I need to add 2 more ...

Hi all, in a lab setup, I have two 2611XM connected via ISDN. Router A (customer) tries to connect to Router B (ISP).This works fine, as long as I choose encapsulation ppp. This does not work when I choose encapsulation frame-relay. Router A (custome...

Hi,I have a rather silly query.I have 1 router and 2 internet links from a single provider.I dont have BGP configured and have configured 2 static default routes pointing to teh respective WAN IP's.This will give me outbound load sharing.What would t...

Ok.. My ISP does not support any type of encapsulation... So is there anyway to set the WAN with a static ip address.... Thnaks Tom

Hi, I have attached my Cisco 877 DSL config that works and is setup as a VPN from a remote office to my HQ. At this remote office where this Cisco 877 router is based any user http and https traffic travels over the VPN and uses the HQ's internet pi...

We have a 3750 switch stack in which switches are rebooting randomly. The question is how to troubleshoot. There are no related error messages in the cisco network assistant system messages. Bandwidth, Packet Error Rate, Temperature, CPU Utilizati...