Routing

Hi, a while back I'd seen a cisco url that had a listing for all the different possible conditions in a route-map... permit sequence with a deny statement in the prefix-list attached to the route-map, etc... has anyone seen that link? Thanks!Lisa G

How can I route IPX/SPX traffic using a Catalyst 3750 switch?

Can anyone give me some configuration advice on the best protocol/config to use for the following setup?I've got a remote office running with a private subnet and a Cisco 1841 router that has 2 ADSL cards installed. Both ADSL cards create a dialer in...

4-decHello,I have an application where I want to bring back (via bridging) 3 distinct private class C 10/100 LANs to a central location. The 3 LANs are at remote sites and I'd like to bring them back to a central site over the internet. I'd like devi...

VoIP call convergence is directly tied to IP convergence. I have read all the responses related to BGP BFD, BGP Neighbor Fall Over, and BGP Session Timeout. My questions is this: Has anyone tested or deployed a BGP solution (over MPLS) that allows...

Hi, I would like to know how to block certain PCs from the network using the mac address.Any help please? Dom

I'm using a vwic-1mft-t1/e1 in a 2811 router, what is the maximum cable distance between stations?

Dear Friends,I am happy to be back, especially with my CCIE number, yes i've done it :) , from the first attempt (Edison, i understood your point!), it was a very tough road, but thanks God i've reached the end alive.NetPro and you guys are one of th...

Hello, I have a simple question which is confusing me. In a Lan setup we have let's say 2 workstations on the same subnet on VLAN-1 and we have a Router FastEthernet also connects on the Switch as the gateway for the same subnet. So both PC's have th...

The HDLC T1 leased line that we use to connect to a partner's site, has always been working fine. Recently, in several occasions, some Telco's problems brought the protocol down on our serial interface, but the remote partner's serial interface didn'...

Hi, I am having two 3750 L3 switches which are configured in HSRP. On 1 Vlan all my servers are conencted.For teaming and HA of servers I had connected another switch,assigning same VLAN and connected to the other giga port in 3750. Is there any conf...

Required redundancy for internet browning (only outbound traffic) and load sharing with two ISPs bandwidth.Note both router Ethernet interface and Firewall outside interface having public IP address. Customer is not looking BGP solution.Anybody can h...

Can someone please tell me if the 7206VXR is the suitable router for a Head Office site with in 2MB uplink to another Head Office and possible 24 branches hanging of the 7206??? I am using frame-relay for most links....