Routing

We have a pretty simple layout with two ISPs. Our preferred path into the network is through one carrier, but the traffic comes into through the carrier we would prefer as a backup. I've prepended the ASN multiple times, but this hasn't fixed the pro...

Hai All,I wud want to set up a MPLS backbone Lab...for this what is the minimum requirement ...how meny routers &...IOS Version ....Please help me regarding this .. can 1700 series support MPLS if so what is the recomended IOS .. i should use ..Than...

Wan/FE04: 10.220.144.5VLAN1: 64.3.217.33PC/FE0: 64.3.217.34I am trying to set up a static route from my FW management console to the PC. From the FW management console I can ping the WAN and VLAN IP. I can not ping the PC. From the PC I can ping the ...

i posted this problem before but i am providing more details right now in the attachment.question i have1- how to enable users to access www.mycompany.com address from insdie the same as outside since the ISP DNS pointing back to me becasue as of now...

Hi, Cisco gurus I'm wondering if someone can help me solve a problem I'm having. This problem has been going on for over 1 year I have talked with Cisco, ISP, Mitel and the problem is still not resolved. Our network is not a complex one. We have a ho...

the router 2801 swicht on, but no output from console portI can not access by any interfaceI think the only way to restore is via hardware (jumper)anyone could help me?thanks

How many NM-CUE (250users/24ports)is supported in C3845 SRTS480 router ?

Guys,i have a request from a customer and am not too sure how to go about it. they currently have a frame-relay point-to-point network. now head office is going to increase their bandwidth so the provider told them to do the following1. add a second ...

Hi guys,I am using SDM for checking the CPU utilization and Memory usage.But when i check the INTERFACE STATUS in MONITOR mode, Only GigabitEthernet interface is showing with its bandwidth utilisation not any Serial Interface is displaying.I want tha...

I am considering what happens to multicast routing in frame-relay hub-and-spoke topologies.As I understand it, there are two problems to be overcome when doing multicast in hub-and-spoke. One is that the multicast router will not forward a multicast...

I can't remember I had this problem before but every let's say 5 minutes I must close the PDM and re-login in to the PDM before I can make any changes again or save the configuration. It also happens when I'm NET idle for a long time. Is there a Solu...

I'm running a Cisco 7604 with 122-33.SRB1 code. When I look at the routing table, I notices a new code. Does anyone know what this code means?ROUTER#sh ip routeCodes: L - localL 172.26.8.25/32 is directly connected, Serial2/1/0.858

Hi, I have a Cisco 837 in VPN mode, I've noticed at nearly every minute the following is displayed on the console, what is it and can I do anything:Nov 7 15:03:52.032: Vi2 PPP: Outbound cdp packet droppedNov 7 15:04:52.037: Vi2 PPP: Outbound cdp pa...