Routing

Hi,I am having CM5.1 and configured SIP trunk (unauthenticated) directly to my services provider. Also i have 2851 router in which NAT is configured with the services provider IPs for call manager and phones.I can able to make calls using this SIP tr...

Hi Experts,I am trying to implement a route map to send the traffic to a particular destination via a particular path(path-2) based on the source address.I need to implement a feature that the traffic will be sent over this path-2 only if the latency...

Please tell me weather router redundancy protocol is available with cisco 1841. In not then from which model it starts.

Hi, I have this config on my Cisco 837, is it secure from the "outside" world? I can't see any rules that block anyone accessing my network, can you? I want the inside to have full access to the outside world, but the outside to have no access into ...

I have 2 routers 2801&3825 connected back-to-back with ethernet via satellite link. Local networks are routed via GRE tunnel. Problem is in bad voice quality beetwen routers due to bid delay in sattelite path. Is it possible to create FR or PPP tunne...

I have a big problem.I have a Cisco 1803 and the external flash is damaged.So i bought another onebut not cisco, a 64 MB FujiFilm CompactFlash.The problem is that i can't format it.I boot from a good flash, i take it out and then introduce the new on...

Dear All,I am facing some strange packet drop issue here. scenario as below:Router A ---WAN CONNECTION--- Router Ba. Router A ping to Router B, no packet drop.b. Router B ping to Router A, no packet drop.c. Router B ping it's own WAN ip address,...

00:00:04: %C1700-3-BAD_EEPROM_VERSION: The eeprom version field has an invalid ntry ()How can I fixed this error Messages.

I have a setup where a bunch of remote site are interconnected via a provider's MPLS network. I connect to the at the various remote sites using BGP on a combination of serial (T1's) and TLS links. Rather than to redistribute my routes via BGP I el...

hi,we r a small isp.for one of our customer ,we want to connect the customer to our nearest link(site) thru p2p microwave link.from that link,i need to route that so that they use INTERNET.The customer also wants to advertise their public ip's in ou...

I am trying to configure the WAN connection on a 2811 series router, but am not having any luck. I'm new to the Cisco world, and I'm trying to set up the router with an existing broadband cable connection. I configure the interface for 'Outside', set...

Ok, A buddy of mine has 2 bonded T1s and I'm upgrading to 4. For some reason he bought the vwic-2mft-t1 and wants to do data only with it. When I go to do the channel group it drops my connection. I can only do it remotely. Any ideas?controller T1...