Routing

Hello,How can I view how many packets have been dropped due to rate limiting after configuring "mls rate-limit multicast ipv4 igmp 500 100" ?.sh mls rate-limit or sh mls stat do not provide such info.Best Regards,Pan

Hello, Just wondering if someone knows anything about the framing issues when Telco ( Any one) gives you a DS-3 and if framing on their end is configured as M13 but on the ATM interface on your Router the framing is configured as C-Bit. Any documen...

I have removed DLCI no 582 from all the interfaces i:e on which it was Switched and on which it was Routed, but it is not getting removed from the Tunnel through which i had routed it.i have attached the sh outputs,can anyone suggest why it is still ...

Hi Guys, we have Cisco 3750-12S-E switch and have configures tunnel interfaces on it for point to point connection. Now the minute i enable IP ROUTING on the switch my tunnel interface goes down and i lose end to end connectivity.

hellowhat is the function of the optional keyword extendable in: ip nat inside command ?

Hi All, I observed one very strange thing in my setup.I am getting periodic traffic drops while sending traffic to a particular group ( Traffic is within the threshold limit , 500K ) .Initially everything goes fine and suddenly the source CE recei...

how to configure 2851 or 7206 router as terminal server? i want also to use tacacs+ server as my authenticator system. thanks,

Anyone, we are currently building new connection to our GRE router. Basically what we want to accomplish is to connect our terminal server (router) to our GRE router to gain access to network A so that hosts from the vlan2 can gain access to devices/...

I was wondering if someone could explain this to me:I have a 3845 router with several 2MFT-T1 interface cards and for some reason when I do a "sh controller t1 1/x/x" I see "Data in current interval (0 seconds elapsed)". Where as all other interfac...

Hello everyone: I have a problem to mount two tunnels with multicast support, I have a server in the IP multicast video 192.168.1.123, group 224.1.1.1 and I must convey this to two multicast tunnels where there are several receivers. But do not get i...

Has anyone managed to get an 1841 with the ADSL port to get on the Internet? I have connected but get no web pages.Here are parts of the config I use:ip dhcp pool client import all network 172.19.16.0 255.255.255.0 default-router 172.19.16.1 ...

I have an ASN and 2 Internet providers. One provider is 3Mb, and the other 10Mb. Because my ISP controlling the 3Mb link has a bigger network than the other, most sources are preferring to take the 3Mb path over the 10. Is there anything I can do wit...

Hello,Here is a short brief over the network:Cisco1800 <---> ASA <---> INTERNET <---> Cisco871The ASA-firewall and the Cisco871 holds an IPSec-tunnel over the Internet and the Cisco1800 and Cisco871 running a GRE-tunnel inside the IPSec-tunnel. The r...

Hi,Can u specify what does this command exactly do "ip verify unicast rpf" .Bcz when i remove this command on one of my interface , i start receiving Checksum error messages .Is there any other alternate for this command..Thnx in advance.

Hi,I'm configuring End-to-End keepalive for two frame relay ends.The config at the both ends as follows:!map-class frame-relay testframe-relay end-to-end keepalive mode bidirectional!interface serial 0/0/0frame-relay class test!!HDQ-R2#show frame-rel...