Routing

I have configured port map in cisco 871w through SDM, but it is not working.Got the next line for por mapip port-map user-hello port tcp 8081 list 15

Hello If I have sub interface s0/2.23 how can I see on the actual interface how much traffic is running over. I asked this question relating to graphing the interface and got excellent response.However, checking the interface itself without graphing ...

I did it couple of times but it didnt work. I am just trying to build MPLS L3 VPN with OSPF as the PE-CE protocol, EIGRP running within the MPLS cloud and PE-PE protocol being MP-BGP. PE router perform mutual redistribution and the routing table at C...

I'm Chinese, there is a problem with my work,thank you all first!########################################the enviroment:UNKNOWN line card: ws-x6148a-ge-txCisco Catalyst 6506 with super engin 2Old IOS 12.1 (Running IOS)new IOS s222-ipservicesk9_wan-12...

hi, my name is martin, im from argentina, im doing a job for myuniversity, conecting 2 networks, one works with RIPv2 ant the otherwith OSPF, th 2 are linked by a BGP link..im using boson netsim to simulate this... i got the two netwoksconfigred corr...

Hi All,I need some recommendation for command 'wrr-queue cos-map' for voice configuration.wrr-queue cos-map transmit_queue_# threshold_# cos1 [cos2 [cos3 [cos4 [cos5 [cos6 [cos7 [cos8]]]]]]]The cos value for VOICE bearer is: 5, VOICE signaling is: 3....

Hei,I have a Cisco 2611XM with RomMon 12.2(8r). Now I want to upgrade this router to 48MB Flash (32 MB Flash is still installed). I opened the case, but I see no further Flash-Slot to insert additional Flash. Who can help me ?SN: JHY0825K285Thanks in...

I have a lab setup and I am trying to configure advertise and non-exist maps.I have two routers "BGP" and "Edge" that are communicating via BGP. I am distributing the default route from the "BGP" router into the "Edge" router and that part is working...

I want to configure one of my switch interface as spam port.Can someone explain the whole process of spamming.

Dear All,Customer switch connect to ISP CE router. customer switch mark voice traffic as EF already, is it necessary to apply service-policy input command as ISP CE router? or just apply service-policy output command under the WAN link will do?Thank ...

I have two core swicthes connected to two diffrent routers .Both are router have seprate links to two diffrent destination.I have data and voice traffic i want to prefer one link for data and another link for voice traffic and i am using eigrp in my ...

Hi Folks,(diagram attached)I have a question regarding route maps + route re-distribution from ospf into BGP.Our network has 3 routers + currently runs ospf between them, we have upgraded our WAN links on router2 + router3-backup link to a new MPLS s...

Hello Experts!as a Security best practice do we need to Disable the Following on the Router:no ip source routeno ip bootp serverat the interface side:int x0/0no ip proxy arpno cdp enableI Do Appreciate ur valuable commentsALI

Hi guys, hope u r doing fine.I have a problem with private vlans.In a shared environment, I am supposed to host multiple webservers under a private vlan like PRIMARY VLAN 1 |_______________________| | || | || ...