Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi, Can anybody confirm whether GGSN Ver 6 & 7 is supported on a MWAM in a 65xx chassis?The IOS Upgrade Planner only has the image for GGSN 5.0 under the 6000-MWAM section and GGSN 6.0 and 7.0 only in the 7600-MWAM section.This has confused me as it'...

I set up a span for just one switch port on our 6509 and started a capture for "all span" but I am seeing traffic that does not appear to be for this port. What could I be doing wrong?

p-allen by Level 1
  • 281 Views
  • 1 replies
  • 0 Helpful votes

Hi everyone could someone tell me what this error means?dslsar_ng_transmit_pak_wrapper: deq(474C0A84). ATM vcd=1 Transmit VCD=1dslsar_ng_transmit_pak_wrapper : encap = DataI'm using IP over ATM, with simple configuration like that -interface ATM0/0/0...

HI,V WIC 1MFT G703 E1 CONTROLLER CARD,It will support 2mbps data in 1841 cisco?KIndly confirm the config:Config tController E1 0/0/0channel-group 0 unframedConfig tint serial 0/0/0:0bandwidth 2048ip address x.x.x.x x.x.x.xKindly revert back

Hi,I think I'm missing something very simple here. I have added a host to port gi1/1 on the 6509. I can ping the HSRP virtual address from the host and I can ping other gateway's elsewhere in the network. However I can't ping the host on the vlan ...

SIZING of the router:Hi All,There is one customer having 700 Users who access for the traffic below from various sites,APPS - Exchange, SAP, Internet, VPN, File Servers, What is the recommended router that I can propose to my customer?Thanks a lot!ci...

Resolved! Route Reflector

Hi All,If I understand correctly iBGP must be fully meshed as iBGP will not forward routing information due to BGP split horizon rules. Therefore we can use route reflectors to forward or "reflect" routes to other iBGP clients.I try to set this up:R...

rossmillan by Level 1
  • 2959 Views
  • 13 replies
  • 0 Helpful votes

I have a situation where I am looking for a routing guru to help - it would be greatly appreciated!!My company has several sites that communicate via MPLS lines over DS3 circuits. These are private IP services so only iBGP is utilized.We recently st...

Ender0519 by Level 1
  • 1087 Views
  • 6 replies
  • 0 Helpful votes

Okay I am a novice when it comes to setting up bridging but I have been asked to help a friend who has his own mini ISP to create something that will work for him. Here is the network layout.there are 2 bridge-groupsBG1 contains 4 membersATM1/0.364...