Routing

Hi:I have to two 2811 routers with following images:Router #1 (C2800NM-ADVSECURITYK9-M), Version 12.4(3d), RELEASE SOFTWARE (fc3)flash:c2800nm-advsecurityk9-mz.124-3d.binRouter #2 (C2800NM-ADVENTERPRISEK9-M), Version 12.4(10a), RELEASE SOFTWARE (fc...

Hello,(i can?t speak english...)I have the Cisco 2600 with a ISDN and a Analog ModulA PC what have a ISDN Card i can connect to the Router an work in my Network.With a PC what have a 56K Modem or a 28k Modem i can connect but not work. Everytime.. 1 ...

Hello All,I have my web server running on private ip (192.168.1.1). i have only one public ip what we use for internet access in office. Now we need to use same for web server.Domain registration, and Managed DNS service has been leased from third pa...

Say I've got multiple interfaces, and my EIGRP topology table is large. We have a connection to a sister office, but don't want that office (and only that office) to have all the routes in the topology table... perhaps just one route. What commands...

Hi,Can someone tell me how to create a virtual template? I need to setup one for the ISDN users to dial in to our network.Does my Virtual-Template config get created around my Serial config?I have dialers created for my clients to dialin as ISDN back...

IF i have host A and B.Host A-1.1.1.1 and HostB 2.2.2.2.Connected by cross cable or HUB.When i ping from A to B for what will be the content in ARP request ?and if Host B reply then A should ping to B.is it ?

Hi,ADSL Router setup at a client site. Router has following config for client network!interface FastEthernet0 description connected to cleint-inside!!interface Vlan1 ip address 172.16.111.254 255.255.252.0 ip nat outside ip virtual-reassembly ip tcp ...

I'd like to configure VoATM over AAL2 trunk. I have the following configuration:Router A:interface ATM0 no ip address no atm ilmi-keepalive pvc 0/100 vbr-rt 100 100 1 oam-pvc manage encapsulation aal2 !voice-port 1/1!voice-port 1/2!dial-peer voice...

hey,i have 2 adsl lines i need to connect to 1 router. i can't change the pvc number or take 1 big line. i also need to have load sharing between the lines.so far i did so by 2 vrfs - only way the lines work together, because of the same pvc as far a...

Can any body clarify static route is classless or not and i am using static route and can i disable classless routing behaviour in my router...

lan1 & lan2 > L3 Switch with VLAN> Firewall> Router > ISPI m having two diifernt lan segment 192.168.1.0/24 and 192.168.2.0/24.I want to flow the traffic for accessing the internet in such way that traffic for both lan segment will pass thru primary ...