Routing

Hi misters, I configured a hsrp in a 1800 router, the router funcion perfect, but after 4-5 hours, the data stop to go to the fibre channel, but I still can ping the other line router and the show standby all still show me the active router 1800.Her...

My 2611xm freezes after decompressing the image and Starting to read memory. Any suggestions?

Everyone,We are in the midst of our yearly survey and I would appreciate if everyone could take a few minutes to fill it out. Your feedback is extremely important to us. The information obtained is used to determine how to make NetPro a better comm...

I am configuring wccp on a 7206 router I did.ip wccp web-cacheI am geting these errors and don't know why.Mar 19 12:52:45: %WCCP-1-CACHELOST: Web Cache 192.168.80.2 lost31w0d: WCCP-PKT:S00: Sending I_See_You packet to 192.168.80.2 w/ rcv_id 000001D83...

Which difference between command set precedence and set ip precedence?NNOV_EQ_2811(config-pmap-c)#set ? atm-clp Set ATM CLP bit to 1 cos Set IEEE 802.1Q/ISL class of service/user priority discard-class Dis...

Dearsir,iam having 1721 router in that 12.2 ios is there .on 1721 router is it possible to do vpn point to point.if it is possible how can i do that can i get any examples.srinivas.D

We are an ISP (downstream of telco) and we have taken Internet Bandwidth from a telco. Our telco has various upstream peering to U.K & U.S. We want that our routes to be directly advertised to our telco upstream partners. Telco is willing to peer our...

Hi Everybody!Below are the two ADC Krone part numbers and details. I would like to find a Cisco alternative to these ADC Krone parts. I tried looking, but no luck as I am not familiar with the ADC equipment. If anyone can suggest an alternative, p...

I have a remote site with Frame with a 1.5 mb circuit no/zero CIR from Sprint. The Hub site has a 12 mb FR Circuit. Remote Site Traffic Shaping is as follows: map-class frame-relay Data-Voip frame-relay cir 1536000 frame-relay bc 15360 frame-rela...

Please refer to the attached diagram.S2-VPN has a static default route to ISP1. S2-VPN and S2-MPLS are both configured for OSPF area 0, they have a complete neighbor relationship and are exchanging routes. I added the 'default-information originate...

i want to test the SLB and when i tried to serach IOS for 2600 router then i didnt found any Image which support the SLB for 2600 router... so i want to know 2600 provide the SLB or not?regardsDevang

Can someone tell me why I am seeing the 72 hour cpu history allways at 100% and the 60min and 1min are normal. the number of packets per secound are around 15KPPS.This is a 7206 router with a NPE-300.The NPE-300 specification say that it can handle u...

Has anybody got any good config for a point to point stm1 link using a POS interface on each side (PA-POS-1OC3)?

Hi,In an effort to better understand cisco qos configuration, I am doing a test on my router. Right now, all I want to do is match some traffic and give it dedicated bandwidth over my vpn and actually see that it is working. It doesn't seem to be w...