Routing

Hi,I wanted to restrict LAN to WAN (traffic going from one vlan to another vlan)traffic on a 3550 switch to particular bandwidth.Can some one help me in providing the required configuration.RegardsSivakondala Rao

Thought IOS would be easy but not to be on this one.Issued the command copy tftp flash command from exec mode. It asked for tftp ip, source file and destination file. The copy went fine.Then to check whether the ios has been copied to flash. I entere...

running voip pri with older altigen pbx which only runs an emulated pri...what router provides ring back required by the altigen.

Anybody knows how to create a BVI interface on 6509? I tried, but couldn't make it. there is no BVI option in interface configuration mode.Thanks

I was wondering if the Cisco ISR 815 would work with my Cox (cable)HSI service here in Gretna, LA.I would like to get rid of the modem and router and replace it with the Cisco.The current modem is a Motorola SB5120 DOCSIS2.0 compliant modem, as it wa...

Here is my problem. I am atempting to connect my 2821 with an HWIC-4T to my 2801 with a WIC-1T via a standard T1 PTP leased line. After a router reboot or an interface shut / no shut the link will come up momentarily and then drop. I have tested t...

hi,i have two 2651XM and both the router installed with WIC-1ADSL card. now my question is can we connect the both the router back to back using ADSL connectivity? i tried to do the same but it was not working so i want to make sure whether its possi...

I always have save the cisco switches configurations thru telnet onto either a word or text file. I notice however whenever I saved configs it saves the page breaks, etc. Two questions, First what is the best way or steps to copy the switch config fi...

Hi, I have 2 routers in 2 locations. The are connected to each other via 2 leased lines on seperate routers. I want to bundle the interfaces. I went through cisco site on multichassis multilink PPP. But it is given only for dialer, BRi and PRI conf...

HiI have a question related to peer group, As the basic advantage of "peer group" is used to reduce the amount of system resources (CPU and Memory) in an update. and it also simplifies the router cofiguration.with the above concept, here is the confi...

this us our first remote site that we want to implement voip and data over a PPP circuit. on the remote site we are using an Avaya 350 gateway using digital phones not IP phones. does the 1841 provide voip services I read it does passthough only? not...

Hi,We are experiencing strange issues with our network. Thought I will raise here and look for different views. We have a problem accessing a host across the WAN from sites starting with ip address 172.31.x.x, but, we also have other IP addresses in ...

HiI have 1841 router. when it reloads it gives following error.Smart Init is enabledsmart init is sizing iomem ID MEMORY_REQ TYPE 0X003AA110 public buffer pools 0X00211000 public particle pools ...

Hi,1)I want to know what protocols are used by VoIP. 2)When using VoIP with products other than Cisco, those uses Auto Discovery, do they do ARP broadcast or what? How should that broadcast be relayed over the WAN??Thanks & Regards,Saurabh Garg+91981...