Routing

Hi there!Currently we have one T1 with Frame Relay encapsulation. We wanna get one more T1 and bond both connections.We have Cisco 2620 and IOS 12.1(4)Which is the best way to do this, CEF or MLPPPoFR. Can I use MLPPPoFR with this IOS, or I need to u...

I have a set of four routers at site 1 exchanging route information using EIGRP over ethernet. There are two serial links from two of the routers to site 2 which also has four routers using the same EIGRP AS as the routers at site 1. The serial links...

Hi there,I am working with a customer in Waukeganand we are attempting to load balancea set of J2EE web services on websphere application with a CSS Switch in front.It seems we are having a problem when a client application that resides on the same ...

Hi, Any idea why I can not remove the deleted file in flash: ?R1#show flash:System flash directory:File Length Name/status 1 12124968 c1700-ipvoice-mz.123-5d.bin [deleted] 2 12504136 c1700-ipvoice-mz.123-15a.bin [24629232 bytes used, 892...

We currently have both a T1 and a 6 meg Cable Connection running through a cable modem coming into our building. We want to use ACLs to route anything outside of our private IP block through our Cable Connection, use the T1 for our private network an...

Hi, Is there any way to disable/switch off the firewall on a Cisco 877 ADSL router so all traffic is allowed in an out?Thanks

Is there any sort of flow chart that shows the steps in which a router performs things for each direction?LikeAccess-ListsNATIPSecPolicy RoutingEtcetcIt would greatly help in the planning and troubleshooting stages. Denny

Dear All,Can anyone tell me, which tool should I use for bandwidth monitor.Rgds,Jitesh

Hi, My question is as follows :-I have an access-list, access-list 99 permit 150.1.5.0 and I want to ONLY allow this ACL as incoming to my router,R4 and no other routes. R4 has 2 serial interfaces s0/0 and s0/1.To accomplish this, I am doing the f...

G'day folks,I have a client with an 1811, and needs to have a DMZ.The issue is the ISP (Videotron - Quebec) will only provide a single subnet for additional IP's.My network guy isn't sure if it's possible to code the Cisco to do a DMZ that's on the s...

using tftp server

I have a problem with my isdn line , I wanted to run isdn as a backup line for my serial 0/1, but my isdn is not firing when my serial interface goes down...when I give backup interface commandand back up delay command in serial interface, I am not a...