Routing

What is use of "no ip directed-broadcast"on interface ?

I installed 1 2MFT VWIC card in 2821 router if I command sh ver I see this card detect but sh run command I can?t see it any controller how can I enable it for E1 configurationThanksrobin

Hi,I am implementing a WAN link that span a carriers extranet environment. The link will have an inside interface (our router) and an outside interface (their router). When we send traffic to our remote site the traffic will be subject to NAT allow...

Dear All,Please attachment.I have 2 location connected to via Lease Line and backup via isdn. When I test isdn line it works fine , but when I give show isdn status bri0 on location 2, it shows me only channel BRI0:1 and not BRI0:2.So what should I d...

Question for the EIGRP gurus out there.. ;-)I am working on a unequal path load balancing config for a customer consisting of 4 routers ..I am trying to load balance destinations Networks on all 4 routers so looking at the "show ip ei topology all" r...

Hi Guys,Please mention what are the differences in comparison with OSPF stub and EIGRP stub w.r.t routes

Hi guys,Can u send me a material for learning EIGRP from which i can have both practical and thoratical explanation short and crispy

Hi Sir,I want to match the prefix address 172.18.252.4/30 using a route map. I understand it can be done by either the following configs:!route-map TESTMAP permit 10 match ip address TESTACL!ip access-list extended TESTACL permit ip 172.18.252.4 0.0....

Hi mates :)I am dealing with a deadline on the project and need some help on HSRP configuration.please see the attached figure that shows the network and IP design.so far I ve configured:trunketherchannelSVIsI m gonna configure OSPF, and HSRPOSPF is ...

Can you have 2 default routes on a router? Since the router to ISP 2 was added, I'm not getting anything from ISP 1 and 1 is my PRIMARY ISP. All routes to ISP 1 are now going via ISP 2.Why would that be?ip route 0.0.0.0 0.0.0.0 Serial1/1 name ISP 1ip...

I am trying to reset a 2620 router. Any assistance would be appreciated.Thanks,Jerry

Hi everyone,I have a small test network setup (virtual).I'm having problems pinging Router 1 from Router 3. I can ping Router 3 from Router 1 fine. Both can ping Router 2 no problem.Here is a brief summary on how everything is set:ROUTER_1 - ROUTER...

Good Day,I'm trying to figure out how to configure traps on a BPX 8600 ATM Switch.I'm interested specifically in the following:cpuUtilizationAboveNormal Specific Trap 20021This trap is generated whenever a BPX/IGX/IPX processor's CPU utilization is a...

Hi. We installed a cisco 7604 with basic configuration to give access to internet,but we're seen that there are problems downloading files. For example, we can connect but after few seconds it's freeze or just the connection is lost.Did we miss somet...

I need to connect Site A to a host on C. This both connect to my network which is site BThere is a route from Site B to site C but when I do a 'show ip route' for that particular host from Site A, I get "% Network not in table"When I do a traceroute ...