Routing

I have an Internet router that has a T1 card. Is it possible to limit one set of IP addresses that access the Internet to a certain bandwidth, while giving another set of IPs full access to the bw?

Hi can anybody help the below mentioned error. Actually I was doing ios upgradation in cisco 2950 switch. and before that I ahve delete the existing ios image from the switch and once new ios image uploaded then I reloaded, but after that switch is s...

I have obtained a Cisco 837 ADSL router, but the image has been damaged so the IOS needs reloading. How do I go about putting the image back on for this Cisco so it restores it as new (factory defaults). Thanks

This has been set up to dial back to our DBU router. Do these configs look correct. These are the errors that I am getting in the routers log.Could this be a service provider issue or a mis-config issue. Please help ASAP. I will rate. %ISDN-6-LAYER2D...

Hi, I am trying to establish a reverse telnet session from the aux port of 3845 router to another 6500 switch.Please suggest how I can do this,configuration assitance will be appreciated.thanksgagan

Hi,I have a 805 router with 8M DRAM and 8M Flash. I want to do an IOS upgrade but the minimum required for DRAM is 12M. Since the router in its usual operation requires less then 30% of memory, I'd like to know if it is possible to install the IOS a...

Hi Netpros,I need to terminate a broadband and a leased line on 1841, for load balancing / failover with NATting.Is it possible, if yes, then how?Thanks & Regards,Sauarbh Garg+919819313892

Hello,I want to connect a second public IP-address to a fastethernet-port on my 1802. I already created a Vlan on port 6.When I want to configure the interface, I can't give it an ip-address. The error is that the Ip-address can't exist on a 2L link....

hi,what is use of Log [optional] cmd in the accesslist.does it logs the voilation of Access-list, if so , is there any cmd/method, to find out who has voilated the Accless list (hit/matched the ACL statement). is there any way we can make out the IP ...

Good Day!i have installed 2 Wirless Link in Branche office Toward the HO.to achieve redundancy.i need to configure 2 static route pointing to the HO.IF The primary route fail the 2nd will be Available.simple config for this situation very much appr...

Hi, I have 3750 on each end of my location .i have 2 wan link on ethernet one is of 45 Mb and other is of 20 Mb both from diff ISP.Please suggest me the configuration i shoud go ahead to achive load balance and redundency on wan links.by business req...

Hi Guys,I have a Cisco 3640 and would like to use it to receive PoS (point of sale) connections. My problem is that I cannot enable pri-group on it, the command is not available on controller level. is it possible using the hardware below , or shou...

I have a simple example of GLBP:R1:interface FastEthernet0/1 description Link to LAN ip address 172.16.9.6 255.255.255.0 duplex auto speed auto glbp 10 ip 172.16.9.1 glbp 10 priority 200 glbp 10 preempt delay minimum 60 glbp 10 weighting 110 lower 95...

Hi Friends, Plz suggest me is there a link which gives the information to select the router models for my network. I need to run ospf over 100 plus locations and under 5 aggregate locations.What series routers should I be using for my area 0 and ...