Routing

Hi,IOS: 12.4(5a)I'm having problems with my 2FE2W. All 3 lights in the back for both ports 9when Connected) flash together (3 per port) on and off every 2-3 sec.The status of the interface goes up and down every 2-3sec.Tried the module in slot2 and s...

Looking to run Full tables on 2 routers running HSRP and multihoming BGP connections between 2 ISPs...I know I need at least 256 megs of ram...Whats the minimum router model I can use?

Do IOS of 17xx support Jumbo packet fragmentation & reassembly ?

Good DayHow can I convince the customer for the major comparisons between:1-WS-SUP720-3BXL : Catalyst 6500/Cisco 7600 Supervisor 720 Fabric MSFC3 PFC3BXL.2-WS-SUP720-3B : Catalyst 6500/Cisco 7600 Supervisor 720 Fabric MSFC3 PFC3B.Thanx

Hi,Will you please send me a complete documetnation of VPN. I have to do it and provide it with a documetnation.Regards,Bikash...

I have read that the 3560G series has an oversubscription ratio of 52 Gbps to 32 Gbps on the backplane. Is there documentation that states how many ports are in each port group and what the non blocking connection to the backplane per port group is?...

the commnad "show policy-map interface s0/0/0" will display the counters of a service policy matching the access-list.how can I clear the matching counters?thanksPH

I am attempting to apply QoS to a tunnel interface using a suggestion I received from a previous post and this is the message I received.Class Based Weighted Fair Queueing not supported on interface Tunnel3Here is what I am using for QoSclass-map mat...

Hi,I recently witnessed a very strange problem with BGP route reflection, and would really appreciate some pointers.Although I have worked with BGP quite a bit, my experience with Route Reflectors is fairly limited.Please refer to the attached diagra...

Hi I have the following questions 1. What does "Validate reply data?" means in an extended ping. So what exactly it validates in the reply data.?2. What happens if i set the datagram size to be 4000 bytes and set the sweep range from 36 to 18024 byte...

hi,i have the task to configure a router so, that it forwards a dhcp request over a isdn line to a dhcp server.is it enough to configure "ip helper-address" to the dhcp server and then make packets to this server as interessting traffic ?if yes, i ha...

Hi,I just can't get to understand this. I'm based at a client site and I have the 877 ADSL Router configured. Router is configured to access the client's network as well as Internet. It also has a config to access my Office via VPN. Access to client ...