Routing

Hi, Does anyone here have a Cisco Laptop bag for sale? It was sold for $20 before discontinunce. But I am willing purchase for $25.I am located in San Jose, California. I can meet if nearby.My e-mail is fullmedia05@yahoo.comBest Regards,Howard

helloo...Can any help me in gettin the command for manually detecting the e1 controller in 2600Regards...Midhun

Dear,We had before been connected to a host with below config;HOSTS LIST OLD--------------151.193.141.1 LB1.DCS.*.*Our old sol: we were adding the HOSTS file at the workstation like below;57.234.224.1 ( private IPs) LB!.DCS.*.*AND we were doing NA...

Hi,I have got a LNS (cisco 7200) and I connect to a LAC.The odd thing is that some users are connected with an IP address but they are experience with problem about opening determined web pages.I can't understand why because they can send pings or tr...

Hi,I have a Cisco 12006 and two STM-16 / OC-48 interface cards. One of them is a one port ISE card and the other is a one port SPA (inserted in a SIP 401). IOS version is 12.0(32)SY recommended for this kind of hardware. I connected both ports back t...

I have a large network with thousands of static GRE/IPSec tunnels across an MPLS WAN. I have to tune the EIGRP hello and hold-down timers on the tunnels due to some problems we are having. When I tune these timers, should I take into account the GRE ...

Dears All, I have gateway router 7206vxr on which I have two wan links. I want to distribute my traffic using Route-Map with named acl. I followed the document related to named aclhttp://www.cisco.com/en/US/products/ps6350/products_c...

Hi everybody,i got following infrastructure;ISR 3845 with IOS 12.4.10a, including NM-1CE1T1-PRI,PVDM2-24DM and HWIC-8A/S-232I have to setup following configurations:1. Depending on the incoming calling number on the PRI interface, i have to path thro...

Can't find this on CCO one way or the other but I need to pull an NM-4T out of a production 3660 and would prefer to do it while the router is powered up.Thanks,Rik

Hi,I recently picked up a 1700 router but am unable to reload the IOS. I'm trying to recover it through ROMMON but it keeps failing:rommon 3 > dir flash: File size Checksum File name 3682960 bytes (0x383290) 0x6dca c1700-os...

Hi,I know that OSPF is used to distribute the routes inbetween the same autonomous system and not between the different autonomous systems. But In the OSPF configuration we dont include the autonomous system number then how the ospf configured router...

i have 4 routers configured to run ospf overframe relay in broadcast mode. The only issue that i have is that the DR can ping the other routers but the other routers cannot ping themselves. They have each others routes in their routing table because ...

Hi,When I ping with the cisco aironet I get this message what is wrong?Thx,Marc

hi,,I want to know about the Autonomous system Types (AS) ???why we catageries AS .. what are the reasons. ???can we use AS number with IGPS ???New method of AS representation ????please forward me any cisco link thanks and regardsAfzaal Qadir