Routing

I want to apply the config below to allow all citrix (port 1494) to be marked with the precedence bit #2. The reason for this is my serial interface of the router at this remote location communicates through an MPLS network that has multiple routers...

Hello,I just got a 1841 Router in order to bond 3 T-1 lines (all of the cards are already setup). My problem is I can't get through the setup to configure the router. I've tried connecting my network cable to the back of the router and non of the l...

Hi,Please help me to configure the router TCP/ IP over X25 (RFC 1598) on serial or EthernetDinesh

Hi, I have a Catalyst 3560 with EI software,two Vlan configured and Ospf routingInterface Vlan 1 with Ip 10.12.0.1 and Interface Vlan 2 with Ip 10.13.0.1.I need to give a default route with static route to hosts in network 10.12.0.0 and I need to giv...

Hi all ,can anyone tell me how tagging dsl lines is achieved, and how they make it so it will only work with that provider !cheersCarl

On a 515E Pix, with restricted license and 32MB of RAM, do I need to buy an Unrestricted license before upgrading this Pix to 128MB of Ram?Or can I just buy the 128MB RAM memory and install it on this Pix without the need of buying an Unrestricted li...

I have a 515E and I noticed it has a card with an RJ45 port in it. Looks to me like a Network Card (those network cards we find in the PCs)Can anyone please tell me what this card is? By the way, nothing is plugged in itthanks

Hi,i inserted a new PVDM2-24DM into a ISR3845 (IOS 12.4.10a feature-set IP-Base).I got following questions:- Is there a firmware onboard on a new module ?- When i like to upgrade the firmware; where i find the firmware on the CCO to download the acco...

router-map name permit 10match ip address 10access-list 10 permit X.Y.Zrouter-map name permit 10match ip address 10access-list 10 deny X.Y.Zrouter-map name deny 10match ip address 10access-list 10 permit X.Y.ZHere route-map is deny but access-list is...

Hi TherePlease helpIn one of our costumer location we have a complicated scenario; the site is in a desert and no physical land lines available, therefore TELCO have agreed with FSO technology to provide 2 MBPS lease line and there will be three sepa...

hi dear all,I have tree seprate tunnels to three braches.How can I make these three tunnel as a backup of eachother?For example if the first tunnel fails the second one cames up and so onregards

Hi,one of my client is facing problem in module 2 of 4506 switch with supIV(image is cat4000-i5k91s-mz.122-20.EWA.bin). the logg file is attached. it gives:Nov 17 01:37:48.719: %C4K_GBICMAN-3-S2WERROR: S2w bus error while looking for changed gbics on...

Hi, We are using Siemens SGSN, Siemens GGSN XP140 with Cisco 7613(Medium Size Configuration) with CPG3300. We have got two border gateways and two core routers connected to Cisco 7613 for internet traffic and WAP/MMS. We are going to integrate anoth...