Routing

Hello,I can not get an CD on the Router, using the Provider Netcologne! I changed the PVC to 8 /35, but it doesent affect!Any other Routers or DSL-Modems, works correct at this Line.Can anybody help me?

Hi , In 8850 MGX switch , i have AXSM-T3-E3 card .After configuring DS-3 line when i execute a dspln command there is a column of "valid interval" in which it shows value of 96 . Whats this 96 value represent infact once my link got down ang when ...

I have a Cisco 3725 router which has an Ethernet port connection to an IBM RS6000 PC and a token ring port connection to an IBM mainframe via a token ring adapter in a 3174 controller (VTAM node type=LOCAL). This configuration works just fine.I have ...

good dayi try to congure ubr7246 as bridge but the cable interface don't support the bridge group. i try tls over cable but for each cable modem ( client connect ) is mapped to different vlan, that avoid modem to get access on single vlan.my objectiv...

Hi - I have looked everywhere for a command that will clear the statistics. I am running the following codec7200-js-mz.121-9.binAnyone know - please help...

I was wondering if anyone else has come across problems when replacing service provider DSL modems with 800 series Routers. I am getting spurious issues around the process taken when doing this; for example, ensuring manual log out of the internet on...

Hi I have a cisco switch port 1 connected to router on fastethernet 0/2.Now I have multiple vlans being carried to Fastethernet 0/2.On the switch I make a trunk port to the router.And on the router what should I do??int fast 0/2no ip address? ...do I...

DEar Sir,What is the maximum speed of link which can be terminated on serial port of 805 router ?Can I get any supporting document ?regds,aman

Can i advertise a natted IP through BGPThe scenario is R1-----R2------R3R2 and R3 are running BGPR1 houses the subnet 10.10.10.0/24R2 will pat these address to a public IP say 100.100.100.100I want to advertise 100.100.100.100 via BGPI have added a n...

Is there in routing protocol like EGP exist

Hi,Can anybody tell me the forwarding rate and backplane capacity of 2811 and 3845.Would appreciate your quick reply.Best Regards,Rahim Amir Ali

Why will disppear the IOS?and my model is 2611 router..If this status happenes,what fator is this basis reason

I have 1841 Cisco router. Today instalaltion of 2 MBPS leased line is done by ISP. I bought 1 WIC1-T card, From Loop I'll terminate V.35 cable in to serial port of router. I want to know if i need to do NATing. Is it neccesary?What is i assign IP giv...

Hi,using NAT with NVI, the following statement: ip nat source static 192.168.255.2 10.0.2.2 vrf kk-C1 extendableenables communication with the internal host 192.168.255.2 using externalIP address 10.0.2.2. The destination address 10.0.2.2 gets tran...

we are an isp, we have clients that have two links from us these links are terminating on ethernet ports on our core switches(conected to the PE routers). The desire is to achieve an auto failover between between these two links for the clients, for ...