Routing

Searching for an option to create routing groups to route to two seperate ISPs -problem being the source subnets are non contiguous so is there a way to tag packets and route other than by IP

From Routing TCP/IP Volume II P212Ex 3-79The book highlights 3 next hops for 10.20.0.0/16 but I only find two: Network Next Hop * 10.20.0.0/16 10.200.60.1 0 200 50 ?*> 10.50.250.1 0 50 ?The thing...

Hi,I'm trying to configure the "PBR Support for Multiple Tracking Options" feature on a Cat3550 with 2.2(25)SEB4 IOS software. I'm following the example in document ID: 48003, but my switch does not accept the command "verify-availability" while conf...

Hello,how many (max number of) cross-stack etherchannel can I setup between 3550 and 3750 ? and only between 3750 ?(IOS ver. 12.2(25)SEE2)thank very much for help me!

Hi there,I'm a little confused because the config look right to me but I cannot connect to the MSN messenger and also the access to webmail (hotmail, yahoo) times-out after a while. There is no ACL or any kind of policy applied but I have the above a...

Hi. Is it possible to have the ASBR (route redistribution) and OSPF ABR function on the same router?

Hello. I found what the performance of VAM modules was, but i could not find the encryption performance figures for plain 7206 with G1. Does anyone know what it's performance for 3DES/AES128,192,256 is?

We are looking to build a fail over network. we have 2 T1's but are looking to get a Business Cable line to use as a backup. Our 2600 router will have to be replaced. I was wondering if anyone has done this and what all you would need to do or had...

Hi guys,i have here a mc3810 router with fxs port. I tried upgrading the ios to enable voip support, but after upgrading and reloading the router, it kept on rebooting. what seems to be the problem ?MC3810 platform with 32768 Kbytes of main memorypro...

Is there a command that I can use to get the serial number form a WIC-1T installed on a Router. I don?t want to turn off the Router and get out the card to see the Serial Number.I appreciate your comments.

I have two providers: AT&T and Lighpath. Lightpath is the owner of the subnet being advertised. I set up the BGP connections through two routers; one to AT&T and one to Lightpath. From the internet, I notice that a tracert and looking glass bgp shows...

I have a new 2801 that uses both a T1 via S 0/2/0 and a DSL modem in transparent bridge mode via FE 0/1. The T1 works fine, however I can't get any packets to go out the DSL interface. FE 0/1 is configured to use a PPPoE connection, and it appears ...

Head end router(3845) is connected to five remote sites via individual T1s. Customer wants to move all the T1 connections from the remote sites to a DS3 cloud and move the head end router to a DS3 so that the Head end router would have a single DS3 c...

Hi,I have 836 router . Ping test with 2000 mtu is absolutly fine ( ping count 1000) but when mtu =1500, lots of drops..Unable to understand that ..ThxG