Routing

hi everybody I have 2610xm with a fastethernet interface ,i just set on this interface no shut command , but this port is working after some times it would be down with this message :FastEthernet0/0 line protocol is down , but in sho interface f0/0 t...

Is it possible to configure PRI (ISDN) lines as a back up to 64 kbps leased lines ? At one location if leased line fails is it possible to initiate a call from PRI line to a BRI line where leased line has failed ? I am able to manually establish ...

Hello,I have a problem with a 7606 router. I have two link to the same destination ( 2xE3) and I want to use per-packet load-sharing for better usage(the same load) of both links( if I am using per-destination load-sharing the links will have differe...

i am setting up a new office and everything was working fine until i tried to surf the net. i looked at the routing table and found this entry - D 10.10.162.0/24 [90/2172416] via 10.10.162.1, 01:36:31, serial1/0:0 when it should be D 10.10.162.0/24 ...

Hii have installed 2 sites.site A & site B the connection between them is leased line 128kbps.i have a strange problem.from site A i want to download a file from site B the size of the file is 500K.sound this strange matter"THE TIME TO COPY THIS FILE...

Hi there all,I've a Cisco 107 with an ADSL WIC, a PIX501 sitting behind it. My ISP has only given me a single public IP. The only place I want to do NAT is in my PIX. The PIX will do PPPoE quite happily.Has anyone a config for running the 107 as a pu...

Hello GentsWhen Testing the 837 router on a dry wire connection to the 6260 Dslam ( 300m cable connected between the 837 router and the dslam champ cables without any pots splitter ),the ATM interface is down ( physical layer is down from both sides...

I have a customer whom is using a Router on a Stick ( 4232 - L3 blade) to route between their production VLAN's. The router on a stick has two externally facing Gateways that he has default route statements in place for that he load balances to for ...

Hi!How can I change metric of one static route on the router, that is propagated with IS-IS ("redistribute connected")? All routes are propagated with one metric, and this only route I want to be propagated with another? Should I use policy-map? If s...

HiIf i would like to know the timeout of dynamic NAT on my router , what's the command i should use ? and if i haven't set the timout , by default what's the timeout value of dynamic NAT translate ?thanks

I am trying to figure out how to utilize more of our available bandwidth on a 200Mb LFN pipe between Houston and San Diego for the migration of a 250 +Gig database. When the DB is copied, the data is stale before it's finished because it's taking ne...