Routing

Dear AllWhat i know is if you there is 2 routers established EBGP via loopback address and the command {neighbor ip-address ebgp-multihop} used without speciying any ttl value in the ebgp-multihop command it's gone working because the default value i...

we have several routers that are looging th e following errors.*Mar 5 19:05:07.219: ILMI(ATM3/0): Sending ilmiColdStart trap*Mar 5 19:05:07.219: ILMI(ATM3/0): No ILMI VC found*Mar 5 19:05:07.219: ILMI: Encapsulation error on o/g ILMI Pdu <ilmi_send_p...

I am trying to configure it as the ISDN switch, and route calls for two Cisco routers, but I couldn't get it working. I am hoping someone here has been worked with one of the AccessSwitch...I can see the Layer 1 and 2 are up, but the layer 3 won't wo...

HiIf i would like to setup isdn peer-to-peer on the both side . I have to use command "dialer remote-name" on the both router each side ? or use on the callin router Thanks

We are an ISP, we are trying to connect to a new International ISP. The transmission between our 7606 router and one drop point is STM4 POS, and from the drop point to the International ISP is STM1 POS. The transmission guys told us it’s OK to make S...

The WPA2 (AES encryption) is not supported?Thanks in advance

hi, I want to connect one small office to branch office with 2611XM. I want these provisions: channelized E1, isdn BRI port, IPSec vpn support, 1 fast ethernet port. are these supported on 2611XM at a time.Regardsskrao

BGP uses port 179 to transfers but what port does EIGRP use??

Hi All,I just have a quick question.As everyone knows, Cisco systems reserve the ip precedence 6 and 7 to internet and network respectively. http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800ca58f.h...

GreetingsThe output of show version is attached herewith. I have a scenario in which I have to use the "ip cef" and "ipsec" between my routers.The central site router is 7507 whose sh version is attached herewith. On this router I am also using the d...

I have two routers 1 with an OC-12 link and the other with a DS3 link. I want the OC-12 to be primary and the DS3 as backup. I set the preferred link on the OC-12 and in my route map statement I set as-path prepend AS# AS# AS# AS# on the DS3 link. Al...

hi, in interview i have faced this question. question: I have 200 servers they are connected to 20 layer2 access switches (each server connected to two switches for redundancy) 20 layer2 access switches are connected to 2 layer3 distribution ...