Routing

Hi All,a few questions about a setup i will be putting into place in a few months.I am going mpls with five remote sites. Two of which are getting two T1's from the same company terminating on a 2821 at each site. mlppp is not fully supported so i ...

Hello:I just upgraded the IOS on a 2500 series router, and the router will NOT come out of boot mode no matter what I try. The config registry is correct (0x2102), but no go. Any ideas? I have reloaded, repushed the IOS, power cycled.Any guidance ...

I have 2 site and a data center (CCM and IPCC server) fully meshed Frame-relay network. The PVCs to the data center are 1.0 Mbps CIR and the PVCs between the sites is 320 kbps CIR. The EIGRP routing protocol would redirect the RTP via the data cent...

HiI have a problem with BGP authentication with Back to Back Link. I am getting Feb 21 17:54:27: %TCP-6-BADAUTH: Invalid MD5 digest from 172.28.14.126(57800) to 172.28.14.125(179)I am sure that both routers has exactly same password as I have removed...

Hi: I have a small network with about 3 edge switches and a core switch. About 100 users and one single VLAN. I am about to create a 3 separate VLANs. I have a few questions about IP Addressing. Since I donot have any routers, does it matter if I use...

I have a customer with a 1721 doing multilink ppp over 2 adsl lines in the UK. I'm trying to add QoS to his link but even though I have the policy created and added to the dialer0 interface and can see packets in each class, the interface never seems...

hi,i want to know with which ip-prec value a cisco router send paket that it self isgenerating.for example ntp, telnet, routing-protocols and so on.is there a url where i can see the values ?thanks and greetings from austria

I have some problems with Cisco 4507R. Please see attached files for the details and network diagrams. Your help is much appreciated. Thanks.

I want to give the limited access to ATM m/cs from other desktops, servers other than ATM switch server. One can not access i.e telnet, ftp etc., can only ping the ATM m/cs from other AMT m/cs, desktop m/cs and servers.What access list should I apply...

I would like to better understand the different loopback commands on the controller of VWIC cards. I am troubleshooting line code violations on a T1 data circuit(with no slips) and worked with a CO tech to do initial troubleshooting.They used their T...

I have a 1721 router, which is working fine however on the wic 1t card on the serial led i am seeing it as an amber light can anyone advise me what the amber light means. Should the light be green

Hi,Can you give me some knowledge about Intelligent routers.Are there any routers currently in the world wide web which can do some additional tasks.for example :listening to a particular port for special type of packets and reacting differently depe...

Does anyone know why I might receive AAL5 length violation errors but not oversize SDU errors: MTU 4470 bytes, BW 3840 Kbit, DLY 20000 usec, reliability 255/255, txload 68/255, rxload 42/255 Encapsulation ATM 23035716 packets input, 10690163751...