Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Err... For some reason, my previous question... got kicked or something? I have no idea, but it seems not to be publicly visible anymore, and I can't see any replies. So, I'm gonna try asking again? I can't imagine what I might've done wrong; it's a ...

Baphijmm1 by Beginner
  • 6310 Views
  • 48 replies
  • 0 Helpful votes

Hi,   I just configure SSH v2 on my Cisco 4331 router. and I change my default SSH port. It is working successfully under LAN network. But I can't access the Router using WAN IP from a remote location. What may be the Problem?      

akhil.s by Beginner
  • 3758 Views
  • 11 replies
  • 0 Helpful votes

Hi All,  I'm a little confused on the IP SLA..I've read the Cisco Documentation, websites, but I still can't grasp the understanding of it.Can someone help me understand it in plainly please? I'm using the following syntax, but when I setup the frequ...

hi,i got a 4321 router that i activated for temporary/eval license. we upgraded it to 16.12.4 and saw smart license started 16.9.xi would need the 'throughput' and CME/uck9 permanent license installed. but the vendor gave us the traditional PAK/PDF f...

Greetings,    I have an issue moving from EHWIC-4G-LTE-V on a 2921 to a NIM-LTEA-EA on a 4331/k9. Basically, once I move it over the modem prefers Band 4 over Band 13, (which the EHWIC preferred), and my signals are much worse, (To the point our NOC ...

wfjones by Beginner
  • 494 Views
  • 0 replies
  • 0 Helpful votes

Hello, I'm a neewbie on the IOS platform after years on the ASA, FTD platforms I am using a Cisco 829IR to deploy IKEv2 between HQ and a remote location. The unit is connecting with IKEv2 againts HQ with Cisco FTD units. This traffic is flowing as ex...

Dear All, We're implementing DMVPN with Dual Hub and approaching Dual Cloud for bank network with hundreds of branches , please advice on the best practice to implement DMVPN with Dual Hub Dual/Single Cloud with higher redundancy and failover. regard...

telesymbol by Beginner
  • 1185 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Routing Protocols

In what situation would you use which Routing Protocols? EIGRP, OSPF, IS-IS, BGP, RIPv2? I'm trying to gather a better understanding what situations call for them. Thank you everyone for your help.

Hello everyone, im planning to config a LACP between XR Router and QFX switch. My questions1- is my LACP connection is correct or the MUX  state must be ATTACHED  not DISTRIBUTING ? 2- how i can config  ip address  ( Gateway ) for the aggregated Inte...

Bildschirmfoto 2021-03-18 um 11.51.14.png
Saskiaaa by Beginner
  • 823 Views
  • 3 replies
  • 0 Helpful votes