Routing

we have 2621 that is connecting to two T1s to our current ISP. We are filling the connection so we wanted to 'off-load' some traffic to a cable connection. I had a consultant configure a 2621 with the attaced config. THe idea is that http/https/ftp g...

Hello is the first time I will configure a Controller E1 for data. My router is a 3725 12.2(8r)T2.My question is how shuold I have to configure this E1 controller to make it work properly?Thanks

The 2811 says it supports partial t3 speeds, how partial are they? What is the maximum useable link speed it can support?thanks

Hi,I am going to purchase a 7609 router for our backbone. I will be having multiple 8 port E1 cards. I know it support MLPPP for a single card across the 8 E1 port. Does it support MLPPP across the E1 cards for atleast 30 E1???Or is there any better ...

hi,I have cisco 2502 router with 2 serial and 1 Tokenring ports, recently this router flash got corrupted , I have replaced FLASH Memory with 8MB single module(another slot is free).I tried download IOS into this router through Hyperterminal , but I ...

If I issue the command:sh ip bgp neigh x.x.x.x advertised-routes and I see that I am advertising a route to the neighbor ( my ISP ), under what circumstances would the route not be propagated throughout the Internet?

Have spent weeks troubleshooting and trying different configurations. Trying to replace a cheapo Efficient Networks DSL modem with a Cisco 1841. Right now have the config stripped down of the more common security aspects for troubleshooting purpose...

Hello all, I know this is a bad question as I have been worked over by it. The company I work for has a remote office on the other side of the country that supports about 250-350 users. We have them as part of our Active Directory domain and we ar...

Ok, please forgive my ignorance.We have a couple hundred remote sites, all running T1s to the Internet on 1841s. The 1841 creates a site-to-site IPSEC tunnel (non GRE) to our VPN Concentrator (nortel) at the corporate office. One site requires addit...

Hi, i hope somebodycan help me, i have a isdn bri back up link, but i would want to have 256kbps of bandwidth, so i want to know if this is posible installing another bri interface in my remote router, and configuring two floating statics routes. has...

Dear All,I have some question about configuring Cisco 3800, does cisco 3800 have feature that automaticaly switch between two wirelles link connected to 2 port on router when one of the wirelless link failed? I am using Ip base software image, do I h...

Can I split my AS into two subnets and wieght each subnet such that a preference is given to one ISP for subnet A and the other ISP for subnet B. Specifically, I have a small AS (globally routable) - call it 10.1.1.0/24 peered using two routers to tw...

I have had various dsl routers - non cisco, my isp generally assigns them an ip address. My question is that how would I set a cisco router up this way, and would I have to run nat/pat on it, also would I need to put a default route on it ?, my othe...