Routing

Router A is connected with Router B with 64k Link and to Router C with 128K link.Router B and C are again connected to WAN cloud and both are receiving Routes via EIGRP with different metric values. These routes are being sent to Router A.Now Router ...

I need loadsharing packetwise over the switchports(WIC-4ESW). Layer 2 portchannel doesn´t work. Loadsharing over eigrp works sessionwise. Have anybody an idea?

Hi,We have an 1841 with a serial WIC which is configured:FastEth0/0 connected to the internal LANFastEth0/1 connected to a sat conn (internet) Serial0/0/0 connected to a frame conn (internet)FastEth0/0 has 192.168.1.21 and 1.20 (secondary) bound to i...

My internet come on two ethernet interfaces. One is satelite(two way), the other is ADSL. Satelite is primar, adsl is secondary. I want when primar conection(satelite)will be about 75-80% full, to start to work the secondary conection. And also adsl...

Hi,I have one question regarding ospf and Eigrp administration distance.If eigrp injects external routes it changes its administartion distance. But in case of Ospf it remains the same. Why it is the case ?can any one explain with example. or refer s...

Dears,configure so that RP spoofing should not happen on R1 loop0R1 ip multicasting-routingloopback 0ip address 1.1.1.1 255.255.255.255ip pim spares-dense-modeinterface e0ip address 10.1.1.1 255.255.255.0ip pim sparse-dense modeip pim send-rp-announc...

I'm updating my routers form feature set: I¨P-ONLY to ENTERPRISE/FW/IDS PLUS IPSEC 3DES, but I realized that the new feature set don't support the "secret" command used instead of the password on the users.In my IP-ONLY version I had the users config...

Hi,Just wondering what is the reason for seeing the following for monitor session 1 being the SMS?sh monitor session allSession 1---------Type : Service Module SessionIs this normal behaviour in my config i dont see anything which r...

hi i have an adsl line,connected to 827 series router.Users are browsing without any problem,continues internet connection is available.but some of the websites are available, like if you go to http://www.icici.com and if you try to login(it's an htt...

I wanna know does rtr 2522 support rate-limit command as mine is not we have ios 12 on it. if not then what is other way to do it....//nilesh

Hello,I have a router that connects with an eBGP neighbour with three physical links with unequal bandwidth. I want to configure load balancing between these three physical links. I found a feature "BGP Link Bandwidth" but I am not sure if this is co...

Hi All,I am configuring a Cisco modem WIC-1AM on a Cisco 1760 router using the following configuration and it won't operate, i issue debug modem and debug dialer but nothing appears.username test password 0 1234!interface Async3 ip address negotiated...

Can a Cisco device be router and bridge at the same time?e.g. bridge serial1 and eth1 and route between serial 2,3 and 4

I have a cisco 1700 Router with one ethernet interface and two serial wan.the first wan is used to connect two distant agencies. Now i want to connect to another companie over the second wan, but this company askes me to use different IP adressing. B...

Is this feature going to be available on the Sup720 plaatform? V1 has been flaky with repeated neighers stuck in init, etc. I was hoping that the new muticast address used for hello's will solve this for us.I have been told that GLBP solves some of t...