Routing

Hello, We have two 6509 switches on two separate locations, they will be connected via 10 GB fiber, can somebody help me with configuring these two interfaces on both ends, the two will be on the same subnet.Thanks and best Regards

Hi I've a quite simple question but I cannot find how to get out of it .I've a cisco 1700 with an ADSL interface .I need to configure the ethernet interface with private IP and assign the one of the assigned public ip to a loopback interface and have...

Looking at T1 WAN link bandwidth usage reports, what are the criteria for time to increase bandwidth? When can I justify to the boss that it is time to add another T1?

I installed the new 831 router and was able to connect via the tunnel from my office. Unfortunately once I disconnected my pc from Fa4 from the router the tunnel timed out and I am no longer able to connect to the router from my main office. I did ...

I have multiple VLANS running on a 6509 layer 3 switch. Currently all the VLANS use the default ip route to a fiewall to access internet. I want to change this. I want to assign some VLANS to a different gateway firewall to access internet. How c...

Does the IOS image c1700-y-mz-122-2.XK2 support AAA feature set?

Hi everyone,this is more of a generic Cisco Q but hopefully you can answer for me: How come all new routers have the power supply at the front? Is there a specially good reason that Cisco told us about?Thanks,G.

Dear All,I am having 2 sites named Parel & Vashi, connected via Cisco 2610 Routers. I want to access a PC and its share located at Parel from Vashi PC. Is there anu configuration required at Router level as OP as both the PCs is Win98. I have applied...

Hi there,I wonder if someone could help me out. I've been tasked with setting up a new branch office that will be on a different subnet to the existing branch office and a different subnet to the HQ site. (Before I go on I'll point out that I am a co...

I know this is a slam dunk, i am new to Cisco Products, so learning the correct verbage and protocol is proving to be quite a task for me. I have an existing PIX 525 {OS 6.3(1)} with 4 VLANs. I am trying to change the DNS that is assigned by DHCP on ...

Hi,I want know a way to log any communication between one interface (on a cisco 1721) and any destination. I know that I can do this with debug command but I know that this busy a lot my router.Any idea?

Hi;I'm trying to configure automatic routing between 2 routers, however the routers are connected to diff. ISP's would HSRP still work or would it be more practical for me to use BGP or some other protocal?

I need to apply some QOS to a frame relay link. However, I am running IPsec over a GRE tunnel across this link. I understand that I can use the QOS pre-classify command to allow the TOS bits to be relayed over the IPSEC link, but when I create the QO...

HiWe have a 1751 router with one 10Mb and one 100Mb interface. The 100Mb is set as a 802.1q trunk with many subinterfaces (one for each customer we monitor/manage) and the 10Mb is our Management server subnet. We have 4 management servers each of w...