Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

What would be the best QOS method to use in the following situation, and where to place the policy - i.e. hub, spoke or both:Main site = DS3 (ATM)Remote sites = T1 (frame relay)Need to ensure that client (remote) sessions with server (main site) get ...

mtobkes by Level 1
  • 561 Views
  • 2 replies
  • 0 Helpful votes

Hello Guys,I want to know that WIC-1ENET Ethernet Card is supported by 2651-XM router without any Network Module.2651-XM have 2 Ethernet Ports. I want to have 4 Ethernet ports so if i install 2 WIC-1ENET Ethernet Card to the free WAN slots, will it w...

Hi thereIn order to pick the correct router for my needs, I need to know the routing capacity of the 2800 series routers. On the 2600 series I'm able to see it directly on the data sheets, but on the 2800 series I can't find it.Anyone got the numbers...

lars by Level 1
  • 1035 Views
  • 2 replies
  • 0 Helpful votes

i am using dialup connection to connect to the internet .The isp assigns ip address with mask 255.255.255.255 and this its the gateway ip as well.my question is how does this scheme works and how the client request is router to the isp

ciscoguy by Level 1
  • 1350 Views
  • 1 replies
  • 0 Helpful votes

I woulk appreciate if anyone can provide me links or documents on design proposals for networks. For example if a client has a RIP network and I need to propose a design based on EIGRP or OSPF based protocol.

adnan by Level 1
  • 756 Views
  • 2 replies
  • 0 Helpful votes

Hi, there.I'm Alex. I have a question about router's crashinfo.Out client's router(cisco 3640) is frequently rebooted by crash lately but crashinfo file isn't in flash. When I enter show version, the following is seen.show version--------------------...

skytosky by Level 1
  • 1298 Views
  • 2 replies
  • 0 Helpful votes

I have an leased line,the modem has been terminated on an serial interface say on WIC-2T through V.35 cable, when i issue and sh int it says Serial Down and Line protocol Down, the DCD-Up, DSR-UP, DTR-Down, RTS-Down, CTS-Up. Can any one give me...