Hi all - I’m doing an implementation of Cisco SD-WAN (Viptela) - around 90 routers (mix of ISR 1111 and ISR 4k)- The problem is - this is a pure on-prem deployment. So, the routers won’t get an internet connection- Everything will be mpls- Since the ...
Forum Posts
HiI want to ask about deployment in my customer, would it be possible to issue license on viptela using plug and play offline? Because the vedge,vsmart,vbond and vmanage doesn't have internet access thanks for help
Hey all, I have a customer with 40 ISR1101s on order with SD-WAN licensing and another ten on order with IP-BASE licensing. I'd like to know if the ISRs with IP-BASE licensing can be managed or, at least monitored by vManage. The locations for the 1...
Resolved! Private sd wan
Hellois it possible to deploy sd wan on a private network without having any internet access ?this means vbond will not have access to internet thank you
Hi, I am wondering if it's possible to protect encrypted malware with the latest SD-WAN security features ex> AMP
Hi everyone I'm having an issue whereby my clients connected to a Meraki MS225 switch (via MR42 AP) are unable to connect to a local printer. This is the scenario VLAN 100 - 10.10.10.0 /24VLAN 900 - 192.168.100.0 /24Local printer - 192.168.100.5 VLAN...
Cisco-Viptela documentation states that the scrollId parameter returned in the1st REST response will expire in 10 minutes.What is the result in cases when there is a long-running request that exceeds 10 minutes?Will the scrollId become invalid and ca...
Resolved! SD WAN SLA Classes
In the below screen shot with respect to loss percentage, if I set the value say 95 (SLA 95) does it means that that the acceptable loss is 95% or acceptable loss is 5%. Basically I want to set the loss not more than 5% . What is the value I should ...
Hi,We have ISR C1111x-8p in our branches with 2 WAN links. Currently the branch traffic is load balanced via these 2 links to go internet. How can we make only biz-internet to be active for serving branch LAN traffic to go internet instead of load ba...
How to configure Cloud OnRamp for SaaS with PPPoE configuration?I have configured our vEdge 1000 with ppp interface. And configured cloud On-Ramp on that vEdge (local-exit). But when Im checking SaaS monitoring page in vManage, vQoE Status is showing...
Hi; When I want to apply the Device template to a vEdge device, it shows me following error message on the vManage. I searched the Internet and found nothing about it. Server error: -----------------------------------^ syntax error: expecting track-...
Can I ask someone with better understanding of sad-wan help on following confusion points? Does service VPN# have to match between sites? For example, there is one DC and one branch connected by the SD-WAN fabric. DC vedge is configured with VPN 10 r...
Hello; my lab topology is a classic SD-WAN where my vEdges have 2 external interfaces inside VPN 0 (one for MPLS and another for Internet connectivity). I've created a Feature template for such an interface but vManage allows me to use this template ...
I have cEdges and vEdges different templates as they are per device, but even though they share the same VPN number I could not see the routes from cEdges on vEdges and viceersa, both have OMP advertised enabled and central policy allowing that kind...
Here is the scenario, that i am faced with. There are two DCs. One is the primary and the other is secondary. Primary DC contains two vEdges and secondary contains one.All the vEdges in both these DC is connected individually to Internet and MPLS ie ...
