SD-WAN and Cloud Networking

Some of my feature templates - when I try to edit them it tells me "Template locked in edit mode.: Template is locked by user:admin since:2019-10-01 04:58:56"I've tried rebooting the vManage, and also the solution here "https://community.cisco.com/t5...

Hello,Reagarding SD-WAN DNA Subscription PIDs, which of followoning PIDs are valid and the order should be placed based on them? DNA-P-10G-A-5Y (Ref: https://www.ciscolive.com/c/dam/r/ciscolive/us/docs/2018/pdf/PSONMS-1003.pdf)DNA-P-T3-A-5Y (Ref: htt...

Hi specialists, I am trying to find the best practice for the SDWAN tracker setup having two Internet links.The site have two vEdges and each each will have Internet link and interconnecting by TLOC Extension.And, each vEdge will have 2 GRE tunnels t...

HI i have couple of ISR 4k i want to attach to vmange my transport only MPLS with no internet is there any way to have the PnP enabled or it must be from Cisco portal and using internet thanks

I have a requirement to export all routes from one VPN to another VPN at a single site. Lets say for example VPN 1 and VPN 2 exist at sites 10, 11, and 12.  VPN 1 at site 12 needs to have direct routes to all sites in VPN 2.  I cannot find a way to a...

Hi, I'm having some trouble achiving the topology (attachment) if it's even possible. Router R3 is connect with two routers R1 and R2. R3 is spoke R1 and R2 are HUBs.I would like to achive that - If everything works fine    R3 gets default-route from...

I facing a situation when the client navigate and all the traffic comming is forwading to the switch core and then to firewall and this is forwarding to appliance ForcePoint "WCCP" to apply a NAT and back the flow to the firewall again by other port ...

Hi sdwan-lovers,Suppose local site has 2 internet channels (ISP A and B), but remote has only one (ISP C). Normally, 2 IPSec are established between sites: A-C and B-C.If ISP A has 100mbps, but B has 10mbps, we normally need to enforce local routes t...

My customer has several Cisco SDWAN (Viptela) sites that consist of a single vEdge/cEdge router and a single layer 2 switch. A single service side vEdge/cEdge port is connected to the switch and is in VPN1. These sites are in locations that are share...

Hello;in cisco website (https://www.cisco.com/c/en/us/td/docs/solutions/CVD/SDWAN/cisco-sdwan-design-guide.html#OrderofOperations) i read that Scheduling and queueing comes before local egress policy but in other websites (https://www.networkacademy....

hi all,  we are in the the designing phase before we deploy viptela. we have around 2 dc and 10 branches. each branch have 1 internet and 2 mpls links. sip service from service provider is provided via mpls (ie service provider sip network reside in ...

HiI'm trying to access the Internet through two paths, which one through local Internet link as the main and the other through DC via WAN link as the backup. (as the drawing below)What we're concerning is the way to fail over to the backup Internet w...